Question about Peavey Audio Players & Recorders
...POWER AMP 1 and 2 input jacks on the front. This will prevent the power amps in the XR8600 from running with no load which COULD damage them. Make the grounding plugs from 1/4 inch mono plugs by ...
...POWER AMP. The pre-amp does some amplification and then it passes the signal along to the power amp, which will do the heavy lifting - driving the speakers. The connection is usually through a ...
Question about Creek Audio Players & Recorders
amp to a power amplifier. I do not have an owners hand book and the net is not clear as to whether it can be done. The power amp is a mcormack dna 0.1 deluxe. Please help me. Hi Lorne, You can use the
...Amp to Power Amp I have an older Kenwood KA-7100 in great condition. I'd like to use its preamp section to run a larger power amp. There are no "pre-amp outs" on the Kenwood. Is there a way to link ...
...power amp or if it has an output IC - that! If you can in anyway disconnect the power supply section from the amp circuit, you can isolate which part is faulty. For if it blows when disconnected from ...
Question about Audio Players & Recorders
power amp, the problem is i have no access to a manual, and i have no idear how to set them up for the best effect. I have tried looking for diagrams on the net but not found any. A better solution is
Question about Yamaha Audio Players & Recorders
...Amp DSP A-3090 Power/function/Remote Help is required on following: 1.Power is turned on only when power button is pressed twice on wall outlet. Power button on Amp do not function. 2. while power in ...
Question about Technics Audio Players & Recorders
...power amp i suggest u check all the paths from pre-amp to power amp. bad resistors cud be it, faulty capacitor cud be draining power to ground. insufficient power supply to final amp cud also be it. ...
Question about Technics Audio Players & Recorders
...power amp IC, which will be on the big heat sink? If you amp uses the latter and not individual separate devices for the power amp, suspect that over the other IC. But if the amp has separate power ...
POWER amp to do anything useful, such as drive a spleaker, or a relay, or a transducer. For your question, most all audio amps consist of stages. There is an input/pre-amp stage (this is usually where
14 questions posted
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions