...motor runs fine removed top cover to see but gears not working and mixer does not spin Any diagnosis Help greatly appreciated The first vertical shaft has a brass gear that runs off the rotor. The ...
motor worm, to prevent the beaters clashing. You may have to put the brass gear in and out a few times to get the right teeth engaged with the worm shaft. Then slide the shaft in, once again observing
...motor by itself at different speeds. If it runs fine then it's time to inspect all the gears in the Transmission Housing(7). Remove all the brown Grease covering the gears. Pay attention in ...
...motor shaft should have no play at all if you try to wiggle the shaft up, down or sideways. If it does, the bearings are available at industrial supply houses and are not realy hard to replace if you ...
...motor runs but the arm doesn't spin. This happened when the gears were changed while in operation. I opened the top to the gears and it looks like one of the brass gears fell apart as there is gold ...
...motor,the new units use an electronic start switch.the old units center shaft and gears have changed.the older units dont have bowl guards and the new units do.(this is a cage that goes around the ...
...motor shaft all seem to spin true, bearings are solid. Any thoughts? Can the alignment of the worm and brass gears be adjusted at all? Does the brass gear just wear really fast? no there are no ...
...motor. The paper clip will ride on the little disk near the top of the beater shaft and the rubber band will exert just enough force to make it want to stay in. We have been using this method for a ...
...replacing the grease, but I will be listening to my mixer very carefully. Put everything back together in the reverse of how you took it apart and you should be good to go. As you reassemble, be sure ...
Question about Kenwood Food Mixers
...via a magnet attached to the shaft. Check the motor brush if it is good or worn out. Lastly check all the switches because if one of them is not working properly you wont be able to let the motor
48 questions posted
Usually answered in minutes!
48 Questions
27 Questions
25 Questions
20 Questions
11 Questions