Canon EOS 5D Mark II Digital Camera "pins memory board" Questions

...memory card no working, how to resolve this problem I have seen this problem some times. Usually it comes from a fail at the CF PCB (compact flash printed circuit bard) and it is necessary to change ...

.....good luck mark 3 pins broken, in the slot where we insrt the memory card. Am willing to risk opening it. Any one with a step-by-step help. Someone who has done this earlier. where is this board? ...

...memory card pusher(spring)got trapped inside the camera, and while ongoing the maintainance they say that the whole 50 not bolts has to be released to take that off or else the spring may catch the ...

...board, software, shutter mechanism etc.) or even the lens. For starters, I would make sure that the lens electrical contacts are clean and the lens is mounted correctly and fully locked home. If you ...

...and the little bottom of its is not on the block position. problem is the memory card reader pins might be bent. i normally replace the main board to fix this issue. cost can go from 75.00 and

...memory works in my PC and also purchased a new CF SanDisk Ultra II 1.0gb - still won't initalize or format. Problem is with the camera not the . Any known fix? No Fix The liklyhood is a pin in the ...

...memory card at fault or that it has been formated as FAT32 on a computer, cameras do not like this setting so you could try formating in the FAT format and then re try formating in the camera. If it ...

...memory card cannot be read'' on the larger display screen. Why is this? We have used these cards for 1-3 years and had no previous problems. First read: http://www.vandyll.net/?p=499 Then read how, ...

...message on the display board of my Canon EOS D60 camera. I bought a new memory card, but the error still comes up. Any idea what I should do? Check pins where goes CF card they might be bent or ...

...memory card in place. I tried two different cards. With no card in place it works fine. check for bent CF pins. Also remove the back cover and make sure the bottom right rear circuit has not come ...