yuki Motorcycles - Popular Questions, Answers, Tips & Manuals

0helpful
1answer

How good is who makes it and is there a yuki

The bike is made in Czechoslovakia. There is a 2010 Yuki Darker model. It is a V twin OHC four stroke with carbs, disk brake on front, drum brake on rear, ( kind of backwards thinking ), CDI ignition, air cooled. Good or bad bike is irrelevant. Even if it is a good bike, where is your nearest service center? Do they have parts on hand or have to order from the factory every time? What is the warranty? When you sell the bike, will the new owner be close to the dealer? My personal opinion is that any motorcycle that doesn't have at least five dealers within 50 miles of where I live can be classified as a YUCCKY motorcycle. Best to go with a brand name; Honda, Yamaha, Kawasaki or Suzuki.
9/19/2011 7:18:43 PM • 2010 yuki 250... • 326 views • 0 helpful votes
0helpful
1answer

I need to know where

7/6/2011 5:38:15 PM • yuki RMCH 50 DD... • 368 views • 0 helpful votes
2helpful
1answer

Need circuit diagram for ARLEC 15e 6-24Volt 15Amp Electronic battery charger OR their later model BC58

I can't find a diagram. The small potentiometer on the control board likely serves as an adjustable component to fine-tune specific parameters. Here are some possibilities: Voltage Regulation: The potentiometer might control the output voltage. By adjusting it, you can set the desired charging voltage for different battery types (e.g., 6V or 12V). Current Limit Adjustment: It could be used to set the maximum charging current. Adjusting the potentiometer allows you to limit the charging current based on the battery's capacity and condition. Sensitivity or Threshold: Some potentiometers act as sensitivity controls. For example, it might adjust the threshold at which the charger switches between charging and maintenance modes. Setting the Potentiometer: Without the specific circuit diagram or detailed information about your charger, I recommend the following general steps: Observe the Potentiometer: Identify the potentiometer on the control board. Note its position and any markings (if present). Consult the User Manual: Check the user manual or operating instructions. It might provide guidance on adjusting the potentiometer. Trial and Error: If no specific instructions are available, start with the potentiometer set to its mid-position. Gradually adjust it while monitoring the charger's behavior (e.g., charging current, voltage). Observe how the charger responds to changes in the potentiometer setting. Fine-tune it based on your specific battery type and desired charging characteristics. Remember that precise adjustments depend on the charger's design and the battery you're charging.
4/9/2024 5:47:52 AM • Motorcycles • 24 views • 2 helpful votes
0helpful
1answer

Mine is a 410JS 1000cc Santana, Spanish made. Mechanical fuel pump does bring no fuel to the carb. Want to shift to an electric setup. What is the best pump? Do I need an overflow-line?

The bike doesn't exist as written. https://www.google.com/search?q=410JS+1000cc+santana We are better with 'year make model 1000cc'. Better to not try and do better than the bike engineers. A mechanical pump runs when the engine is turning, an electric pump will run as soon as the key is turned and create pressure all the time. It would have to be an in tank electric pump or it will burn out. Electric pumps are cooled an lubricated by the fuel passing through it. If it is a carbureted engine, you are pressurizing the carb bowl. If injected, it may already have a fuel return. Check the mechanical pump for a torn diaphragm, they are easy to change. ..
3/19/2024 9:52:56 PM • Motorcycles • 27 views • 0 helpful votes
1helpful
1answer

What is the length of lift cables on a 1993 model 2693 hilo camper and any info on what after market part to use ? thanks

The lift cables on a 1993 model 2693 Hilo camper are 30 feet,2 3/4 inches long and fit the standard height lift of 11 feet 8 inches high to the top of the overhead. The lift uses two cables. According to a Hi- Lo camper travel trailer forum, cable replacement is basically the same on all years and models, with the main difference being the length of the cables from model to model. You can use a cable cut chart to find what cable length you need for your camper, and you'll need to know your year, model name, and box (body) length: Lift cables typically wear out after three to five years, so it's important to replace them as needed and keep them regularly maintained.
4/11/2024 2:06:02 PM • Motorcycles • 18 views • 1 helpful votes
0helpful
1answer

Xv-bd707 won't start. it stands. "Please wait" in the window.

This is a combo unit. Confirm the disc is playable. The problem may not be in the machine. Check that the power plug is firmly inserted. I have provided links to manuals for the machine. If the troubleshooting therein fails, the remaining option appears to be contacting the manufacturer. Such details should be in the manuals. Pioneer XV-BD707 Blu-Ray Disc Receiver Manual ' HiFi Engine PIONEER XV-BD707 OPERATING INSTRUCTIONS MANUAL Pdf Download ' ManualsLib
3/5/2024 2:19:32 PM • Motorcycles • 27 views • 0 helpful votes
0helpful
1answer

2011 Jurgens Safari Oryx Off-road Caravan. I would like to download owners manual for Jurgens Oryx 2011 please?

Question edited for clarity. Unable to move from Motorcycles as site is broken for moderation. See if this link works better for you. This is a South African Caravan and we are in North America. https://www.google.com/search?q=2011+Jurgens+oryx+manual ..
3/2/2024 5:12:40 PM • Motorcycles • 26 views • 0 helpful votes
0helpful
1answer

Cleaned my carburetors and the Jets and now my bike won't start. I have a spark but it won't start.

All questions need FULL 'year make model', as the first 3 words. Then there are 10,000 categories listed by 'make year model'. So we are working blind. Make sure gasoline is being delivered to the carbs by removing the fuel delivery pipe. Carbs come in different systems. If it has a float bowl on the bottom, tap it with the handle of a screwdriver as it may be stuck. Turn the engine over. If it doesn't start, remove the spark plug and see if it is wet with gas? You need three things for an engine to start Clean gas A spark at the right time Compression You have one thing missing //
2/21/2024 5:36:50 PM • Motorcycles • 31 views • 0 helpful votes
0helpful
1answer

Hero Honda Karizma R valve clearance please?

Question edited for a lot more clarity. Hero Honda Karizma R 0.10 mm on both inlet and exhaust https://www.facebook.com/WonderMechanicAjayKumarSavita/photos/a.1615112108760566/2952364698368627/?type=3 ..
3/1/2024 1:06:53 PM • Motorcycles • 26 views • 0 helpful votes
0helpful
1answer

Lexmoto Michigan EFI 125 Euro 5. How to remove the battery cover on a Lexmoto Michigan 125 efi please?

Question edited for clarity. Usually, there are two ways, you either remove a side cover and it comes out sideways, or you remove the seat and it lifts out. https://www.google.com/search?q=lexmoto+michigan+125+efi+battery+cover+removal https://www.google.com/search?q=lexmoto+michigan+125+efi+manual ..
3/9/2024 3:37:06 PM • Motorcycles • 22 views • 0 helpful votes
0helpful
1answer

Were do the fuel lines go to on a mountop 150cc

This particular unit has a typical GY6-style engine with a fuel line designated from the gas tank to the carburetor distinguished by an in-line cylindrical fuel filter located near the center of the line. Best to locate the carburetor distinguished by the location of the air filter, there should be a hose going from that unit up into the gas tank. Ideally, remove the gas tank entirely and it should reveal the gasoline lines directly to the carburetor. The photo shows the fuel line/filter indicated in red, and the location of the carburetor within the blue indicator. carbfuellocation-undefined-undefined-0.png
2/27/2024 7:07:40 PM • Motorcycles • 26 views • 0 helpful votes
0helpful
1answer

2019 Yamaha YZF R15 V3 with 34,000 km driven. The issue is bike at low rpm bike get off frequently and won't start. Sometimes when I accelerate there is lot in delay in acceleration.

Question edited for clarity and add maker. Try cleaning the Throttle Body. This bike works the same as a car. My first thought was that it has a diaphragm carburetor and the membrane was punctured or split. This bike is not sold in North America https://www.google.com/search?q=yamaha+yzf+r15+v3+clean+throttle+body ..
3/13/2024 5:48:33 AM • Motorcycles • 20 views • 0 helpful votes
0helpful
1answer

How to fix a Pit Bike with no spark please? nosprk pitbike

Question translated for clarity and into written English. :>D Test the coil, test the CDI or Contact Breaker Points if it has them. All questions need 'year make model', or at very least 'make and model' please. Help in the link https://www.google.com/search?q=Pit+Bike+with+no+spark ..
3/6/2024 5:58:27 AM • Motorcycles • 22 views • 0 helpful votes
0helpful
1answer

My bike will start and run then it shuts off I replaced plugs and wires but still does it

If a bike runs and then shuts off the reason is lack of fuel. All questions need 'year make model' as first 3 words. It is important. ..
2/28/2024 1:57:08 AM • Motorcycles • 24 views • 0 helpful votes
0helpful
1answer

Suzuki Bandit 1200. It was starting with a boost. I left the crappie battery in and now I can't boost to start. The fuses are fine what could it be?

Question edited for clarity. Does it have an aftermarket immobilizer? https://www.google.com/search?q=1200+bandit+immobilizer Is it the fuel injected model? Injection doesn't work if the battery voltage is below 11 volts. ..
3/3/2024 11:40:12 PM • Motorcycles • 22 views • 0 helpful votes
0helpful
1answer

What weight oil for 2014 sportster 883n fork oil

I always use Harley Davidson Fork Oil.
2/6/2024 7:38:57 PM • Motorcycles • 30 views • 0 helpful votes
0helpful
1answer

How do I reset 2007 Victory Vegas 8 ball petrol sensor please.

To reset you need to follow this steps below
1.Turn the ignition switch to the "On"position
2.press and hold the trip reset button on the dashboard until the fuel gauge reset or blinks
3.Release the trip reset button
4.Start the engine and let it run for a few minutes to allow the sensor to recalibrate
5.Turn the engine off and then restart it to ensure the reset was successful
2/8/2024 3:04:00 AM • Motorcycles • 28 views • 0 helpful votes
0helpful
1answer

Can I get a WIRing DIAGRAM for a SOQC935-MBK please?

All question needs FULL 'make model (what it is)' please, first 3 words. You posted to the category 'Motorcycles'. Sylvania Made in China fire? https://www.google.com/search?q=SOQC935-MBK Same as the Dimplex. The Chinese will sell to many name brands and just change the label on the back. Page 6. https://cdn.shocho.co/sc-specsheets/Dimplex_DS5629_Stove_Service_Manual.pdf https://www.google.com/search?q=soqc935-mbk+wiring+diagram ..
2/9/2024 6:19:06 PM • Motorcycles • 27 views • 0 helpful votes
1helpful
1answer

What year and size is my bike I just bought?

That is the model number for a 1990's Yamaha RT 100A - 100cc Dirt Bike.https://www.google.com/search?q=YAM3UL0097..
9/11/2023 8:17:53 PM • Motorcycles • 980 views • 1 helpful votes
0helpful
1answer

Hero Honda Karizma ZMR fault code No. 54?

Question edited for clarity and add MAKER, toss in some CAPS! Bank Angle Sensor https://www.google.com/search?q=Karizma+zmr+fault+codes+no+54 ..
1/18/2024 2:12:03 AM • Motorcycles • 28 views • 0 helpful votes
Not finding what you are looking for?
yuki Logo

4 questions posted

Ask a Question

Usually answered in minutes!

Top yuki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66847 Answers

Are you a yuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...