Xispa FLHR Road King Peace Officer - Recent Questions, Troubleshooting & Support - Page 2


Hi, Anonymous you need to repost your question under the Chevrolet category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on May 17, 2020


Hi, Joe you need to repost your question under the Kubota category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on May 17, 2020


Hi,Simo you may have a faulty starter motor, bench test the starter with a 12-volt battery if you get a negative or poor function result, perform the following procedures:
1. Decontaminate and undercut the armature commutator segments as necessary.
2. Check segments with an ohmmeter, probe each one and the segment next to it for shorts.
3. Take the armature to a professional and have it tested.
4. Test the field coils, and the brush plate with an ohm-meter for opens, shorts or grounds.
5. Replace brushes if less than 0.438"
It is generally cheaper to overhaul-refurbish a starter motor than buying a new one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://xjbikes.com/forums/threads/1980-xj650-maxim-starter-problems.118479/
https://www.youtube.com/watch?v=-YO6gs98w1A
https://www.xjcd.org/book/export/html/35
https://www.partsfish.com/page/oem-parts-for-yamaha
http://mybikemanuals.com/yamaha/

Motorcycles | Answered on May 17, 2020


Hi, Carol you need to repost your question under the John Deere category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on May 17, 2020


Hi, Anonymous you need to repost your question under the Kubota category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on May 17, 2020


Hi, Anonymous you need to repost your question under the Scottrade category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on May 17, 2020


Hi, Anonymous and the usual suspects are:
1. Spark plugs in bad condition or have an improper gap or are partially fouled.
2. Spark plug cables in bad condition.
3. Battery damaged or nearly discharged, should have 12.5 volts.
4. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Throttle controls not adjusted correctly.
6. Water or dirt in the fuel system.
7. Water or dirt in the carburetor.
8. Intake air leak.
9. Fuel tank vent hose and vapor valve plugged, or the fuel line is closed off, restricting fuel flow.
10. Choke valve inoperative.
11. Engine lubricant to heavy (winter operation).
12. Ignition is not functioning properly (possible sensor failure).
13. Faulty ignition coil.
14. Valves sticking.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
http://www.ch250.net/techtips/24.htm
https://www.motorcyclecruiser.com/what-to-do-if-your-motorcycle-doesnt-start/
https://docplayer.net/142517262-File-honda-airblade-manuals-archive.html
https://www.partsfish.com/page/oem-parts-for-honda
https://upeqarsilib.files.wordpress.com/2016/07/17.pdf

Motorcycles | Answered on May 17, 2020


Hi, Anonymous you need to repost your question under the Mercury Outboards category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on May 17, 2020


Hi, Mel and the usual suspects are:
1. Improper clutch adjustment or not disengaging.
2. Bent shift shaft.
3. Shift fork bent or seized.
4. Gear seized on the shaft.
5. Gear positioning lever binding.
6. Shift return springs weak or broken.
7. Shift return spring pin loose
8. Shift mechanism arm spring is broken.
9. Shift mechanism arm is broken.
10. Shift drum is broken.
11. Shift lever loose on the shift shaft.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.motorcycleclassics.com/tech-corner/1983-suzuki-gs1100e-zb0z1207zbea
https://www.youtube.com/watch?v=4KQRcReVVPQ
https://www.manualslib.com/manual/1076648/Suzuki-Gs850g.html
https://www.partsfish.com/page/oem-parts-for-suzuki
http://gsarchive.bwringer.com/mtsac/~cliff/storage/gs/1982_GS850G_Owners_Manual.pdf

Motorcycles | Answered on May 17, 2020


Hi, Anonymous you need to repost your question under the Bicycle category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on May 17, 2020


Hi, Anonymous you need to repost your question under the Lego category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on May 17, 2020


Hi, Holly and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the choke.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. Fuel injectors stuck open.
13. Quick disconnect check ball stuck.
14. Compression below 75 PSI.
15. A stuck-bent-burnt valve.
16. Improper valve clearance (too tight)
17. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a cursory reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
18. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
19. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
20. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections are loose or connected to the wrong cylinders.
21. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
22. Faulty neutral, clutch, kickstand safety switch.
23. Faulty fuel pump or fuse or relay.
24. Faulty or corroded run/stop switch.
25. Tilt sensor needs a reset.
26. Security system not disarming alarm needs a reset.
27. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.hayabusa.org/forum/threads/engine-wont-start-turn-over.150240/
https://www.motorcyclecruiser.com/what-to-do-if-your-motorcycle-doesnt-start/
https://www.manualslib.com/manual/926988/Suzuki-Gsx1300r.html
https://www.partsfish.com/page/oem-parts-for-suzuki
https://www.manualslib.com/manual/868326/Suzuki-Gsx1300r.html

Motorcycles | Answered on May 17, 2020


Hi, Anonymous you need to repost your question under the Caravan category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on May 17, 2020


Hi, Anonymous for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can not find the best tool you ever bought for your Big Boy, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.google.com/search?sxsrf=ALeKk00wE8Otej-xxWw6hR4xkvvAAnF_zg:1589696653907&source=univ&tbm=isch&q=wiring+diagram+for+a+big+boy+GPR+200R&sa=X&ved=2ahUKEwio7OzCobrpAhVxTt8KHbAgAFIQsAR6BAgHEAE&biw=1440&bih=757
https://www.youtube.com/watch?v=Bb8ievq1TsE
https://subskingcomwohn.files.wordpress.com/2015/10/big-boy-scooters-service-manual.pdf
https://www.gumtree.co.za/s-motorcycle-replacement-parts/big+boy+part/v1c9218q0p1
https://www.google.com/search?sxsrf=ALeKk00jV-ylqxAvx1YVG6Jb0-hQajYmJg:1589696780456&source=univ&tbm=isch&q=big+boy+gpr+200r+owners+manual+pdf&sa=X&ved=2ahUKEwjF55j_obrpAhVhU98KHfUgDA4QsAR6BAgGEAE&biw=1440&bih=757

Motorcycles | Answered on May 17, 2020


Hi, Anonymous you need to repost your question under the VW category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on May 17, 2020


Hi, William for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can not find the best tool you ever bought for your Kawasaki, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful
https://www.google.com/search?q=2006+ex250+ninja+ignition+switch&sxsrf=ALeKk00i-0kNX8Bkt3PMv9Z02k48fyOuoQ:1589696136171&source=univ&tbm=shop&tbo=u&sa=X&ved=2ahUKEwiN8fzLn7rpAhXumuAKHQZvBkkQsxh6BAgMECw&biw=1440&bih=757
https://www.amazon.com/Ignition-Switch-KAWASAKI-EX250-NINJA/dp/B01LJPR4R6
https://www.manualslib.com/manual/741337/Kawasaki-Ninja-250r.html
https://www.partsfish.com/page/oem-parts-for-kawasaki
https://www.manualslib.com/manual/1490141/Kawasaki-Ninja-250r.html

Motorcycles | Answered on May 17, 2020


Hi, Robert you need to repost your question under the Yamaha ATV category, not Motorcycles. Thanks, Gregg

Motorcycles | Answered on May 17, 2020


Hi, Dawid for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can not find the best tool you ever bought for your Honda, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
https://www.google.com/search?sxsrf=ALeKk03cJGWSMDlD9DsT2ZmsAAWslcunXQ:1589695774382&source=univ&tbm=isch&q=Bmw+f800st+wiring+diagram&sa=X&ved=2ahUKEwimibufnrrpAhVKc98KHYu_AMgQsAR6BAgKEAE&biw=1440&bih=757
https://f800riders.org/forum/showthread.php/223242-wiring-diagram-F-800-ST
https://www.carlsalter.com/bmw-service-manuals.asp
https://www.bikebandit.com/oem-parts/2007-bmw-f800st/o/m18325
https://ownersmanuals2.com/bmw/f-800-s-2007-owners-manual-59115

Motorcycles | Answered on May 17, 2020

Not finding what you are looking for?
Motorcycles Logo

Popular Products:

-10 questions posted

Ask a Question

Usually answered in minutes!

Top Xispa Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6342 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

richard libby

Level 2 Expert

209 Answers

Are you a Xispa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Xispa Motorcycles

  • Forum

View Most Popular

  • Xispa Motorcycles
Loading...