Question about Suzuki GSX-R 1000 Motorcycles
You can make ur own dealer switch to get the fault code on ur clocks so u know what is at fault. These are the steps- turn ign off, hit kill switch, under rear seat there is a two wired connector, use paper clip or wire to connect the points, turn ign on, turn kill switch off and u should get fault codes up and go from there. This will save you money rather than a garage charging hours rate to do the same. Good luck
Posted on Dec 29, 2014
Hi mat when turn bike on no problems ride and accelerate no broblem go as fast as I like but when slow down by holding my clutch in or gear down f1 light come on and find it hard to idle when it come to a stand still, so I switch the bike of and start it f1 is gone. and so on.
Posted on May 03, 2014
F1 means there is a fault stored for the Suzuki agent to read, repair and remove.
The fault could be anything from a fuel injection/engine management error to a low battery.
Posted on Mar 24, 2011
Tips for a great answer:
May 15, 2016 | Goes Motorcycles
Aug 09, 2014 | Suzuki GSXR 600 750 1000 KEYCHAIN KEY RING...
Dec 25, 2012 | Suzuki GSXR 600 750 1000 KEYCHAIN KEY RING...
Mar 18, 2011 | Suzuki GSX-R 1000 Motorcycles
Apr 24, 2009 | 2002 Suzuki GSX-R 1000
797 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: