Wont start showing spanner sign turnig over not firing

check the coil if ok check rectifier and also fuel line.

check connection from battery to starter solenoid. try crossing the solenoid connecting the 2 bolts on it together with spanner, does this turn the engine.. it the engine/frame earthed to the battery

Place the key into the #2 position (do not start engine). With the oil remaining light showing on the odometer, press and hold reset post for 10 seconds until it starts blinking, then let go. Press it again for 5 seconds and it should reset back to 100%.

first you need to test circuits see where the fire is going in and coming out when you find the spot that you have no firing coming out theres your demon replace it also check your fuse if it didnt show signs of a problem befor you parked it make sure you ignition relay or fuse isnt blown also check your ignition control moule and pick up some call them stators

Press the clear and 8 keys at the same time. The service code will appear in the corner of the screen. Report back with the code and we can diagnose from there.

I just checked on that one, they said to disconnect the battery for 5 minutes, and the lights will reset? I have heard this but never had to try it. Your spanner is scheduled maint and the oil light you know. And they both should be resettable. Hope this helps.

see if there's not secured to the shaft with a screw inside at the bottom of the bit. try to slack it by turnig it clockwise. then catch a 19 mm. open end spanner in a bench wise put the shaft with its two flat sides in the spanner and with a pump pliers catch the bit and unscrew the bit turning counterclockwise this time

Spanner means that it is due for a service, it should show for a period of time when you start the car and revert back to miles after a period of time, the length of time the spanner remain gets longer as you go more miles overdue for service. When you get it serviced the mechanic will reset the spanner/ Service interval

The spanner or wrench you are seeing indicates how many miles are remaining before your vehicle is supposed to have the oil changed. Normally this is about a 10,000 mile interval and may be reset after an oil change by following this procedure...



Do the following steps:
Move start switch to position "2".
Within the first 4 seconds after moving the start switch to position 2, press the reset button for the trip counter twice within one second. The display for the service request is activated for about 10 seconds.
Within these 10 seconds, move the start switch into position "0". The service request continues to be displayed.
Press the reset button for trip counter and keep it pressed.
Move the start switch into position "2".
Continue to hold the reset button for the trip counter pressed until the signal sounds and the new start distance appears in the display (it takes about 10 seconds).