Where is the fuel filter located on the 1984 1200cc Hondo Golf wing. Are there 2 filters.

There is no serviceable fuel filter on the GL1800 Goldwing...

The air filter is a long rectangular shape and is located is the front section of the air intake cover. Dead center and right on top of your engine. It is square rather than round like most but still sits right on top of your carburator/fuel injector. 2 wing nuts release it.

The are two locations.The fuel filter is either under the fuse box there are 2 canisters the bigger one is the fuel filter .If not there then it is under the back pasager side wing you have to take the inner protection off.The fuel/diesel filter is under the bonnet, on the left side behind the engine bay fuse box. Adjacent to the 2nd low pressure fuel pump. Thanks.

you should be able to open the glove box an take it out you will see the air bos there remove 2 wing nuts and remove lid an change air filter the fuel filter is located a few inches from the fuel pump on the right side of bike you will see the fuel line it should have hose clamps if it has been changed befor

Hello,

I see that your question hasn't been answered in six months. I was doing a search on users that are having problems with Gold Wings and came across your questions. The following information should be helpful.

The Fuel Pressure Regulator is located is attached to the rear end of the right-hand fuel delivery pipe.

You can locate the fuel filter by doing the following:

1. Remove the seat by lifting it straight up and away from the frame. Locate the fuel lines where they go into the gas tank. Follow the fuel lines until they go into the filter. The filter will be located between the fuel pump and the gas tank.
   
2. Unbolt the filter from the mounting bracket with a socket and a ratchet. Pull the filter away from where it is mounted to the bracket to allow better access to the fuel lines.
   
3. Loosen the hose clamps that hold the fuel filter on with a screwdriver. Pull the fuel lines off of the fuel filter. If the fuel lines are held on with a quick connect fitting, lift the tab on the fitting with a flat head screwdriver and pull the fuel lines off of the filter.
   
4. Install the new filter in the same orientation as the old one. Ensure that the arrow on the filter is pointing towards the fuel pump.
   
5. Slide the fuel lines onto the new fuel filter. Tighten the hose clamps with a Phillips screwdriver or slide them on until they clip into place if they are the quick connect style.
   

Bolt the fuel filter back to the bracket that holds it in place, ensuring that it is securely fastened. Turn the ignition on and crank the engine to make sure that there are no fuel leaks. Reinstall the seat.

If you find the information in this post to be useful, please vote.

Best Regards,

Oz

i do not know but give this websites a try www.alladtadiy.com and www.autozone.com if all fails stop by your local Honda dealership in the part department and they be able to print you off the pictures and diagrams you will need so you know where it is located wish you the best of luck Michigan Man

if you have the digifant fuel system.fuel filter is located under the vechicle near the rear axle. the cis fuel system fuel filter is located under the hood on the fuel distributor.you have to remove air filter housing to get to it.besure to relieve fuel pressure before replacing fuel filter.if not gas will spray everywhere can cause fire.gas pressure is very high.

The fuel filter is under the car next to the fuel pump reservoir and looks like a large, metal container. Arrows point the direction of fuel flow through the filter. Banjo type fittings with copper gaskets connect the fuel lines to the filter. Always replace these gaskets any time the fittings are loosened.



Follow the replacement procedure below to change out the existing filter.

1. Relieve the fuel system pressure.

2. Raise and safely support the rear of the vehicle. Have a pan ready to catch the fuel that will run out of the reservoir.

3. Have a rag handy and wear safety glasses when loosening the fittings. The system will be under pressure and fuel will be sprayed.

4. Hold the filter with a 19mm or 22mm wrench and loosen the fittings with a 17mm wrench. Wrap the filter and wrenches with a rag to contain any pressurized fuel. Have the catch pan ready.

5 Disconnect the fuel lines, loosen the mounting bracket and remove the filter.

6 Install the new filter but do not tighten the mounting bracket yet.

7 Make sure all fittings and sealing surfaces are clean. Install the banjo bolts with new copper gaskets and torque to 14 ft. lbs. (20 Nm).

The fuel filter on your 2003 Buick Century is located on the left side under the back dor and is up into the inside rocker panel. The filter is held in by a strap that has a 1/2 inch bolt and the filter itself requires a 13/16 wrencha dn a 5/8 line wrench when taking it apart. The line coming in from the trank side has the push on connector that you need to push it towards the filter body and then squeeze the two plastic wing to let it release the filter. The new filters now come with a new plastic wing so it yo really get fustrated with it you can force it and it should still be okay as the new one will work when you put it back on.

MAF is located in the air filter box.
As far as i know, ur oxygen sensor has one wire, not 2 and is black if i remember.