Question about 2008 Keeway Arn 125
My husband has a keeway ARN 125cc scooter and he has a problem with it over revving and he says it is like it is trying to get stuck into the rev mode, I would like to clean his carb out but have no idea where to find the carburetor on his scooter and we can't seem to find a manual for this? could someone help please thanks @
Hi, W32twood and the usual suspects are:
1. Throttle cables improperly adjusted, pinched or need lubrication.
2. Idle adjusting screw needs to be backed off.
4. Air fuel mixture adjusted too lean start with 2 full turns.
5. Intake system air leak.
6. Fast idle choke ramp is not releasing.
7. Faulty automatic choke.
8. Broken throttle return spring.
9. Damaged diaphragm or slide.
10. Faulty MAP, TPS, ATS, O2, sensors or wiring/connector.
11. Multiple carburetors not in sync.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
think broke my scooter and it my only way of getting to work Please help...
gy6 carb for 150cc scooter engine
2006 Keeway ARN 125 150 Scooter Repair Manual Download Manuals Technical $22
Keeway Scooter Parts Racing Planet USA
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e
Posted on Dec 10, 2017
if you look down from the handle bars to where your feet go you will see a little rectangle on the plastic, if you pop this off the VIN is underneath
Posted on Jun 01, 2009
first of all, was the bike running, then parked for a signifigant period of time? if so, the first thing your going to want to check is the fuel system. theres a fuel hose running from the fuel tank to the carburetor. remove the fuel line from the carb to check the condition of the fuel. fresh gas has almost a clear look. if it appears to be fine, then proceed by checking the carb to see if there is fuel in the reservoir. at the bottom of the carburetor, there should be a small screw. turn it out counterclockwise to see if gas comes out from one of the overflow fittings on the carb. if it begins to leak, then you most likely have enough fuel in the carb to start it. if it comes out of the hose looking dark, or smelling kind of funny, then youll need to clean the fuel system. to do that, you must drain all of the old fuel, flush the fuel tank a bit with fresh fuel, refill it with fresh fuel, and also clean out the carburetor. if youve never done this before, i would reccommend having a technician do it for you. lost parts or mis-adjusted carburetors can not only cause mechanical damage, but also be a potential safety hazzard due to performance problems.
if the fuel looks and smells fresh, then your going to want to check for ignition next. remove the spark plug from the cylinder head, attatch the boot to the top of the plug, make sure the electrode end is touching a good grounding point on the engine, and press the start button. BE CAREFUL on this step. if the plug sint grounded well, it could lead to you getting an electrical shock from the ignition system. its a good idea to hold the spark plug or boot with insulated pliers during this step, just as a precaution. while the engine is turning over, watch the gap on the spark plug end to see if there is a noticable spark. it should be fairly easy to hear as well. if there is spark, then your ignition system is most likely in good condition, so move on to the next step. if there is no spark, try this process over with a new spark plug. if the new one still doesnt spark, there is a problem with one of the components in the electrical system, and that should be further diagnosed by a certified technician.
I hope this helps you out a little bit. these are the first things that I would check. If you know the fuel system is in good condition, and you can see that there is a good ignition source, then you have a mechanical problem that would require more information to attemp to diagnose. if you have any questions, feel free to contact me. Ill be happy to further clarify or explain anything that I mentioned here.
Posted on Jul 28, 2009
Go to: http://keewaysuperlight.blogspot.com/ and you will see how to repair your Keeway Superlight panels with pictures and instructions.
Posted on Aug 04, 2010
Tips for a great answer:
Apr 23, 2014 | 2007 Keeway Superlight 125
Aug 05, 2013 | Keeway Matrix 150 Motorcycles
Sep 21, 2012 | 2010 Keeway Hacker 125
Apr 07, 2017 | Keeway Motorcycles
Oct 31, 2011 | 2008 Keeway Matrix 150
May 04, 2009 | 2008 Keeway Superlight 125 II
Mar 25, 2009 | 2008 Keeway Arn 150
Mar 13, 2009 | 2008 Keeway Superlight 125 II
May 26, 2020 | Motorcycles
265 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: