Question about 2005 Kymco Zing 125
01159 596969 And ask for james Lisk. It's a charity in Nottingham called Wheelbase that sell's spare parts and specializes in Chinese and Taiwanese bikes
Posted on Aug 05, 2013
SOURCE: No power on my Kymco Zing 125
Usually the main fuse is located within 12" of the battery. If the fuse is okay then check that the battery has the red wire on the positive terminal and that connections are tight. Check the wiring harness for loose connections. If your bike has a kickstand safety switch then be sure the kickstand is up when starting. Be sure the kill switch is in the correct position and that you have gas in the tank and the fuel is turned on.
Posted on Mar 14, 2009
Not always necessary to change the regulator/rectifier. Check all connections to make sure they are clean, use a good contact cleaner and finish off with dielectric grease on your electrical connections.
When some bikes get a few years on them the connections get dirty. Check to see if there are any burned or discolored wires anywhere around the regulator. The FIX on some bikes is to cut the connector completely out and solder the wires together and either seal them with heat shrink of a good electrical tape. Loose or bad connections get hot. As long as the regulator and rectifier are working there is no need to replace them if the connections are good.
Ride Safely, Ed
Posted on Apr 09, 2010
SOURCE: What is the oil capacity
I would put in 2 qts and then slowly add part of the third till the level comes up. No bike, not even a big one holds much more than 3 qts oil. But I'm sure you will safe at putting in 2.+. Hope this helps.
Posted on May 28, 2011
Tips for a great answer:
Sep 30, 2011 | 2005 Kymco Zing 125
Jun 24, 2010 | 2005 Kymco Zing 125
Apr 08, 2010 | 2005 Kymco Zing 125
242 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: