Gear lever doesnt click - cant change out of 1st

I'd start by looking at the clutch hydraulic circuit. "...could not put gear into 1st or reverse" suggests that the change cables on the transmission may be failing. And just in case, make sure there's nothing in the cabin that's jamming the gear change lever.

if it is s manual box remove the gear lever tower from the top of the box and see what damage was done to the bottom of lever and/or lever pivot pin in the tower. Remember normal gear boxes require a gentle shift to allow the syncro rings to work properly and if you want to do racing changes get yourself a specially built box.

Sounds like the clutch plates may be stuck together. Happened to me after a long trip in the rain and bike sat for a few weeks after that. Had to take the cluch discs out and clean them

Hi, you might find the nut holding the clutch basket onto the shaft has come loose, so instead of pulling the clutch plates apart you are just pulling the clutch basket along the shaft.
or if the bike has sat for a while you might find the clutch plates have stuck together, this isn't that rare, you can start the bike and roll it along at about 1st gear speed, then click it into gear, then pull the clutch in and rev the engine, this should make the plates loose again. hope this helps, please rate, thanks, good luck

Mate I had this problem, it was the compression, had to get new piston and rings. good luck.

Your link broke off. What might have happened is the car got stuck in 1st, and when you shifted to second, the link broke. Not too clued up on your car, but you probably need to drop the gearbox. On some cars you can take out the shifter without having to drop the box and still see if the link is broken. Good luck

1st gear syncromesh Is worn or broken. This usually is caused by forcing lever in when clutch is not disengaging fully, or changing gear with out disengaging clutch.
MMP