Where are the fuse placements on a 1989 honda cbr 600 all the fuses. and I am getting no spark. The start button connection was out and I tried to fix it. But it will not start now.

Do the plugs spark out of the engine so you can see ...

Left side fairing panel under the handlebars.
its probably a stuck solenoid,under the rhs seat panel.
or bad connection to the starter

It sounds like the starter relay is getting lazy on you. Double check that the plug in connector is making contact through it. And double check your fuses. The starter relay has internal switches for both the ignition power and the high power connection for the starter motor. I don't think it's maintaining the ignition power for you.

.032"

first replace the plugs and check for spark if you dont have spark theCDI box might be the problum. the jump start might have poped the fuse to the ING look at the fuses and find the one that has got ING on it and replace it hope this will help

Check your starter selenoid state?
Good enough?

Fuse blown.

Try lift the gas tank before the bike a-frame, you should see them. Good?

Check the fuses. Next, check for spark but with a new spark plug. How good is the battery? Try a jump start from your car battery. Is the kill switch on? Does the side stand have a kill switch? Is it working properly? Check the operation of the ignition switch and all kill switches with a volt ohmmeter. You should be getting power into and out of the ignition switch.

Check the wiring harness. Did a wire come unplugged? Are all wires clean and with solid connections? Any abraded or pinched wires? Is the bike in neutral and the neutral light is lit up? If no neutral light, check the neutral switch and neutral switch wire on center casing. If still no spark, get CDI system and coils checked at the dealers shop.

Please rate this as a top answer. Thanks