Question about 2000 Yamaha YZF 600 R thunder cat

Open Question

Hi, I have a datatool 433 fitted to a

Hi, I have a datatool 433 fitted to a Yamaha Thundercat.
Just got back off holiday and battery is flat.
How do I stop alarm going off when i disconnect battery, so that i can try and recharge it.
Is there any specifics when putting battery back on.

Many Thanks

Mark

Posted by mark4_miller on

Ad

5 Related Answers

Anonymous

  • 101 Answers

SOURCE: removal of battery

Hi .... On your fob you have a few options, you have to press the fob to place it in service mode.
1.Disarm
2.Turn ignition on
3.press and hold the smaller of the two buttons on the fob until you hear a beep.

This is service mode but you still get a beep every few seconds which will drive you nuts! It must have a backup battery built in because it continues even without the battery.

You can take it out of service mode by pressing the arm/disarm button.

Posted on Jan 04, 2009

Ad

Anonymous

  • 26 Answers

SOURCE: I purchased a 1995 yamaha virago and put a new

I dont believe this bike has a rectifier, just a generator, located in the bottom forward engine case. You can test the generator by charging the battery, put the bike on the center stand, attach a DC volt meter to the pos and neg of the battery and run the engine, the volt meter will show 13.6 - 14 volts if the generator works. It is possible you got a battery with a dead cell causing it to never get fully charged... sometimes they're dropped during shipping and other handling. charge the battery and check the voltage, if it seems good, take it out bring it to an auto store and ask them to load test the battery, theyll do it free at most places. if it fails...the battery you got was a dud, take your receipt to the store you bought it and explain what happened and they should honor their service and replace it free. good luck. if the bat is good and the alternator is not charging there are a few other directions to go...

Posted on May 02, 2009

Ad

Anonymous

  • 653 Answers

SOURCE: I have a 2003 yamaha yzf 600r thundercat and I

It has automatic choke driven by engine vcuum. Good?

Posted on Apr 30, 2010

Anonymous

  • 91 Answers

SOURCE: Hi..i need to no how to fit a new back brake lever

Hello Simon,

If I understand your question, the following should help.

The installation is easy; the brake lever installs using your existing pivot, and the brass sleeve simply slides out allowing for the replacement.

Posted on Jan 09, 2011

Michael Green

  • 3799 Answers

SOURCE: Does any exhaust fit a yamaha thundercat providing

You could fit any exhaust, But exhausts are designed for specific engines for a reason. They work best when they are used on the correct engine. Lots of things are taken into account when designing an exhaust, such as capacity, rev range and number of cylinders. An exhaust from a Honda SS50 wouldn't work on a Fireblade, so buy the correct one for your bike, it will be worth it.

Posted on Mar 08, 2012

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...
2000 Yamaha YZF 600 R thunder cat Logo

Related Topics:

440 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

gbob59

Level 3 Expert

3063 Answers

randymanfive

Level 3 Expert

501 Answers

Cindy Wells

Level 3 Expert

6222 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...