Question about 1997 kawasaki ZX-6R Ninja

1 Answer

My 1999 600 wont start smells rich it wants to start but wont also the clutch dose not have to be pulled to start and feels like if it did start it would be in gear without pulling clutch

Posted by edge_billy on

Ad

1 Answer

Anonymous

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 12 Answers

Rewaork the carb clean it out and the jets as far as the jamming situation wow if it start i gear that simply means it struck in gear or jam un jam it by checking first the cable if not there then next the gear box

Posted on Feb 19, 2010

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Clutch dose not disengage when trying to put it in gear 98 goldwing


Is there air in the clutch line does it feel real spongy or is the clutch plates stuck together and won't release??

Apr 20, 2014 | 1998 Honda GL 1500 Aspencade Gold Wing

1 Answer

Seized engine


Could possibly be Crank shaft, crank bearing, or dropped a valve. Im assuming when you say it wont start, you mean it wont even turn over. If you say the drive sprocket wont turn then someting is stopping the crank shaft from turning. You will need to explore more of the engine to find the exact problem. Workshop manuals can be found online and downloaded if you look about, they will tell you exactly how to strip the engine down.

Jul 29, 2013 | Suzuki Motorcycles

1 Answer

Smells flooded?


If it is getting too much fuel you should be able to pull a vac hose such as the one to the PCV valve and make the engine speed up.
If it is too rich could be a fuel pressure regulator or injector problem.
Pull the pump relay and see if it starts then runs out of fuel.

Sep 05, 2012 | Ford Bronco Cars & Trucks

1 Answer

I have a 2000 zx2 escort..the clutch feels loose and cud not get in gear..now the gear shifter easly goes into gear but the car will not move..the shifter feels very loose as so does the clutch..could


Sounds like the clutch friction plate was on the way out when you bought the car. The smell you mentioned was probably from the clutch plate slipping.
You need someone knowledgeable to check the linkage is correctly set up and advise if a new clutch plate is required.

Jan 30, 2018 | Ford Escort Cars & Trucks

1 Answer

The washer has a burn smell what can it be? it fill up with water and would not agitate


Clutch could be locked up see this post Clutch Fix and see if it will get you started to DIY.

There is Service Manual link at that post for the FAV6800A/FAV9800A machines.....Rich

Jun 12, 2010 | Maytag Neptune FAV6800AW Top Load Washer

1 Answer

My maytag neptune tl fav6800aw top loader sounds bad and wont spin or drain half the time any ideas were to start. It is about 4 years old


Sorry I missed your post I feel I can help you if you want DIY the fix. From your description it sounds like you have a Clutch malfunction see this post Clutch Fix for support.

Let me know if I can help you thru the issue………Rich

Jun 10, 2010 | Maytag Neptune FAV6800AW Top Load Washer

2 Answers

When clutch pedal depressed clutch does not move away from fly wheel started 2 1/2 days ago. is cluth hydraulic or cable? thanks ray


in a car this 'new' prob. hydraulic. check clutch fluid reservoir- should be near brake fluid res.- will be smaller- if fluid is low, or empty- may be clutch master cylinder, or clutch 'slave' cylinder is leaking. check for leak under car, should smell like 'brake' fluid. if your brake master- both reservoirs are to the full line, and there's fluid under car, close to where clutch master is located, or near front of , or side, of tranny- then it's a clutch problem of some kind (as if you didn't already know this!!) relatively new vehicle (by my standards!), should have hydraulic clutch.
do you mean- when you depress the clutch pedal, it goes to the floor, and you can't shift into any gear??
should have asked this first! front wheel drive or rear? i'll guess front wheel drive. may have hyd. fluid leak in master or slave. (apologize for 'terms', but as 'male & female connectors', it's traditional, non-racist and non-sexist nomenclature!!) gotta' be careful, in the 21st century!! if there are, as i stated previously, 2 similar reservoirs, close to each other, then you prob. have hydraulic clutch. may need 'master' rebuilt, or replaced, or 'slave' replaced-it can be rebuilt, but prob not cost effective!
sorry to be 'long-winded/ texted', good luck!

Oct 23, 2009 | 2000 Hyundai Accent

1 Answer

Engine management light came on after cold start speeding and car feels like it is spluttring also smell some burning like clutch


You more than likely have a turbo boost hose leak or vaccum leak, and the burning smell will be the catalyst getting hot from unburned fuel..The car will run very rich with a boost leak.

Jun 25, 2009 | 2005 Audi A3

1 Answer

Clutch wont engage.


no doubt your clutch has gone again, possibly the slave cylinder.

Mar 19, 2017 | 1999 Suzuki Grand Vitara

Not finding what you are looking for?
1997 kawasaki ZX-6R Ninja Logo

Related Topics:

169 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6418 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

217 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...