At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Sounds like its running too weak ,thats why it runs ok with the choke on, check for air leaks around carb- engine and carb - airbox , use wd 40 and engine note will change when leak found..
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Are you giving it any throttle when you try to start it, yu shouldnt, keep throttel completely closed when using hte choke or you will flood the engine
the motor wont rev high on choke.the motor is suppose to fire once on choke. then turn the choke off.pull the start cord and the motor should start and run.check that the throttle conrol is on full. it should run fine.
I suspect your warm start procedure is the fault, the manual is not correct IMO. Any choke on a warm engine causes flooding, try this, if no better post back or return it for warranty replacement.
Start Procedure Cold:
Ignition on/off to on.
Set compression release – optional step even if saw is equipped with a compression release.
Pull (close) choke, set fast idle (done when choke closed on some saws); pull starter and listen for an attempt to start. once heard (usually two pulls; no more than 4).
Set compression release – optional step even if saw is equipped with a compression release.
Push (open) choke pull starter until it starts. (usually first pull).
Warm:
Ignition on/off to on.
Set compression release – optional step even if saw is equipped with a compression release.
Pull (close) choke, set fast idle (done when choke closed on some saws) – Do not pull with choke closed.
Push (open) choke, pull starter until it starts. (usually first pull).
If you have more questions or need additional help please reply below and I will get back to you. Thank you for using FixYa and Good Luck. HTH Lou
×