'06 Boulevard c50T - how do I replace left frnt turn signal

Remove lens, disconnect wires inside assembly(take pic first) remove nut from back of post, pull off broken signal and replace

Unless it is specified, you may have an uphill battle.

There should be two small philips screws on each side of the bezel. Remove those screws, then turn the bezel slightly counter-clockwise (if you're facing the front of the bike) and if should pop loose and pull out.

The turn signal indicators are attatched by a M6 screw underneath, they do not screw in like most bikes.

Both the rear and front indicators are mounted on a nice chrome fitting that can easily be removed. The rear one is bolted through the fender, access the bolts from inside the guard. The front ones are mounted with screws underneath the chrome mounting. Once you remove the mounting the wiring can be easily unplugged and indicators replaced.

that depends were you are in the world, but yes the oil seal can fale in a very short time take off the back wheel and disk you can see the seal from there, even if your cearfull hook it out and replace it woth a new one,,, just push it in squirly and tap it home with a hammer using the old seal as a drift,,,

two Philips screws on the lens and it

reach screwdriver down between headlight and marker to releace clip, pull forward.

Here you go, removal & installation of:

Front Parking/Turn Signal Lights:

• Remove the screws from the the lens and separate the lens from the bezel
• Remove the screws from the turn signal housing and pull it out
• Turn the bulb socket CCW 1/3 turn and remove it
• Installation is the reverse of this procedure

Side (Front) Marker Lights:

• Remove the screws from the marker lens
  
• Separate the lens from the headlight
• Pull the bulb from the back of the lens
• Installation is the reverse of this procedure

Hope this helps

Mike