My high beam wont work on my yamaha xj600..iv checked fuses and that dont do it.. i have the low beam but yet whe i turn to high beam nothing and its not the bulb any help would be amazing and thanks alot for the help

check the headlight relays ,
Check for possible faulty light stalk switch also. Dash lights may fail with this possible cause.
Check fuses

Check bulbs. had this happen on my intrigue had no high beams but lows worked. If bulbs are fine check fuses and relays.

check all your fuses usually this will be the problem check for loose connections also

Other possibilities are; the bulbs themselves, burnt or corroded bulb sockets, or a bad headlight selector switch.

did you check for a relay in your fuse panel? there should be a relay that controls your low beams and one for your high beams. check for that and then if high beams are working swap it with low beam relay. if your problem switches to low beams working and high beams not working replace the bad relay.

i had same p w 1996 gmc chgd bulb chgd switch checked wires in steering coloumfinmally went under dash where your left boot would be and wiggled a 3quarter by half inch relay and done it lite up all day of jackin 2sec fix

voltage regulator... just a guess, but better get it checked.

The headlight high/low beam switch assembly.96 Safari has the turn signal stem as the high/low beam switch.Removal of the steering wheel is necessary to get to the switch assembly for replacement.