Question about Motorcycles
How to deselerate 2007 Burgman 400 @
Hi, Leonel derestrict is a negative term rider's use to express their wish to improve performance on their bike or scooter. Depending on the country and motor vehicles laws some bikes and scooters are designed to conform with said laws and their performance is slightly lower than other countries. All vehicles in the world are designed to perform at 75-80% of their maximum potential, this ensures the longevity of the engine. Derestricting or improving performance is always possible on any vehicle but the tradeoff of engine longevity numbers go down, how much depends on the number and type of performance upgrades. Your local dealership or reputable independent shop are best equipped to provide you with technical data and willingness to comply with your needs.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Posted on Feb 12, 2020
I had the same problem until I found out that when you put the Burgman on it's center stand, it pushes a small round metal pin (spring loaded or something similar) that limits the Burgman to 1st gear only. Some kind of safety feature, I guess. You can see the little switch if you put the bike on it's side-stand, get down on the right hand of the bike and look where the centre stand meets with the body of the bike. My switch was stuck in permanent "on" so I just pulled the pin to it's full extention with a pair of pliars, then cut it with a junior hacksaw.
Posted on Jun 03, 2009
you reach under the front of the scooter between the headlight and the fender. find the wire that goes to the connector of the headlight. it is directly behind the headlight. unplug the connector, pull the plug off the headlight. remove the rubber cover/boot off the back of the headlight. this is now the tricky part. there is a clip that needs to be unhooked and moved out of the way. remember how you unhook it because you will have to rehook it when you install the new bulb. this hook is a stiff wire with a loop on one end. push on the loop and move it to one side and it will come off the back of the bulb. the clip is attached and will not come off. you should use gloves to remove the bulb. the oils on your hands are not good for the bulb. use glove on removing just in case the bulb is good and you need to use it again. use gloves to install the new bulb. there is only one way to install the new bulb. there are tabs the extend out from the base of the bulb. you can kneel in front and reach your hand under to install the new bulb while you watch the insertion through the glass. rotate the bulb until you feel the detent that allows the bulb to fit into position. both bulbs have the tabs in the same location, ie. the detent tab is about at the 8 oclock position. replace the clip (insure that it clips on to hold the base), the boot and the connector.
Posted on Jun 28, 2009
Now thats scary but when you feel just below your instyrument panel, is a black/grey butterfly shaped cover, your hand fits under it.. you can pull each side off. its brute force ... there are two retaining positions each side so be carefull dont snap it in half.. do side by side.. is easiest.
Posted on Jan 28, 2010
SOURCE: locatio fuse box burgman an 400
For the K8
The fuse box is under the cover just below the instrument panel on the left hand side. So you need to yank that off first its retained by 4 clip n fit rubber buttons. do side by side.
Posted on Jan 28, 2010
On the earlier models there are two self tapping screws with x heads on the underside lip of the rear section you undo these and the rear panel lifts up and out on 2 plastic hooks built into the panel. (it feels like its not going to come off at times) you can then get to the bulbs I would replace both at the same time as the other one will go in a short time as the odds are they were fitted at the same time in the first place.
Posted on Mar 03, 2010
Tips for a great answer:
Feb 21, 2018 | 2007 Yamaha Majesty 400
Aug 15, 2017 | 2007 Yamaha Majesty 400
Mar 21, 2016 | 2008 Suzuki Burgman 400
Mar 05, 2016 | Genuine OEM 1997 1998 F-150 Genuine Ford...
Dec 10, 2013 | 2007 Yamaha Majesty 400
Feb 16, 2013 | 2007 Yamaha Majesty 400
Aug 23, 2011 | 2007 Yamaha Majesty 400
Nov 10, 2009 | 1994 Chevrolet Suburban
Sep 02, 2009 | 1997 Honda Steed
Jan 03, 2020 | Motorcycles
58 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: