How do you remove tail light assembly on 2008 suzuki C50

unbolt the passenger seat..the bolt is visable. Then you slip it apart from the main seat it will come apart from that strap. The main seat then has 2 bolts you can remove if you need to get it off.

sound like the harness may have a bad connector in the loom your wireing digram would allow you to find all connection points. you may be able to by pass the problem.

i got the same problem i have been over the whole bike cant find the problem i was hoping someone had a dealer find the problem on there bike. i m still lookin i thought key switch but i have one tail light workin all flashers work and sometimes the fuel pump wont start its a very crazy problem.

the light is a full assembly. the soft plate in front removes with a single screw from the bottom center. it makes access to the nut holding on to the light assembly. the headlight must be removed to get to the end wire connections.

You willl have to loosen the nuts that retain the tail light assembly to the fender, then access the turn signal from the front of that assembly. You'll need an open-end wrench to break the t/s nut loose.

on the 2005 intruder there is a small screw under the plastic wing shaped chrome thing under the headlight. this wing thing can then be pulled to the front and u have access to the nuts and bolts that hold the indicators to the rest of the bike.

THERE IS THREE BOLTS UNDER THE REAR MUDGUARD (FENDER) THEY ARE DIFFICULT to get at. once they are removed the tail light unit will pull forward.
hope this helps.

2 phillips screwa hold the headlight ring on, remove them headlight will pop out