Question about 2004 kawasaki KX 250

1 Answer

Replaced geerbox oil in kx 250(04)now bike wont finde 3rd,4th,5th. it wos fine before.please help me!

Posted by hutch_1 on

Ad

1 Answer

thomasnee

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 677 Answers

Thats a strange one.For some reason it may be just locked in 2 gears at one time.Lift the bike of the ground onto some sort of stand.Don,t start it.Take the plug out.Run the rear wheel backwards and forward.Clicking the gears at the same time.This might 'unlock' a wound up box.Being off the ground you can't hurt it.Just try different gears and in both directions.I hope this helps,because its a strange problem if all was ok beforehand.Thanks

Posted on Aug 30, 2009

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cant find transmission forks for a 92 kx 250


Look in eBay, Google, local wrekers or dealers

Mar 23, 2010 | kawasaki KX 250 Motorcycles

1 Answer

2006 R6 Shifting Problem


Howdy: The 3rd and 4th gears are used the most, after awhile the dog and shifting forks get worn more. Try changing to Yamaha Lube simi-syn oil 10/40. Drain oil after warm up (get trans oil warm). The oil is in a silver 4gal containe at the Yamaha dealer. This oil has helped me.
Good luck - Doug

Dec 09, 2009 | 2006 Yamaha YZF-R6

2 Answers

How many cc's of engine oil with filter change does the bike hold


hi mate 1st run the bike till it gets warm this helps the oil become thinner so it drain the hole lot 2nd undo plug underneith engine 3rd replace oil plug once oil has drained 4th undo cover where oil filter is located 5th take oil filter out cleaning the housing it in 6th replace new filter and cover 7th undo filler cap and fill with oil and once the oil has reached 1/2 - 3/4 full on the oil sight glass located on side casing stop refilling and replace plug then start the bike for 2 mins and turn it off let the oil settle and check oil again if below 1/2-3/4 on the glass just top it back up a little good luck bud

Aug 25, 2009 | 2006 kawasaki KX 450 F

2 Answers

Clutch slipping


Clutch plates are probably toasted. Drain the oil, remove the cover where the clutch cable goes into and check them out. Not hard to replace but you do need a special tool to get the plates off/on.

Aug 20, 2009 | 2003 kawasaki KX 125

1 Answer

1st, 3rd & 5th gear


how about the 4th gear?

if its fine in the 4th gear, its your transmission. if you have automatic I would try to replace the auto trany computer if you could find it at the wrecking yard.

Aug 14, 2009 | 2003 Hyundai Santa Fe

1 Answer

Bike cuts out at 10,000 rpm


Eventually it won't start at all if you keep redlining her like that. My advice to you is get a faster bike.

Jun 20, 2009 | 2005 Honda CBR 125 R

1 Answer

My motorbike wont go into 3rd,4th,5th and 6th gear


make sure your foot is not holding the gear selecter after changing into second while riding as this would not let the bike go any higher through the gears

Feb 22, 2009 | 2007 kawasaki Z750

1 Answer

Help with puzzle 100 seven squares


Hi,

first square is the only one that is straight, all the others are at an angle..
1st - top four pins on left hand side
2nd - top row 3rd pin, 3rd row 2nd pin, 4th row 3rd pin (position 4) 2nd row 5th pin
3rd - 1st row 4th pin, 3rd row 1st pin, bottom row 2nd pin, 4th row last pin
4th - 1st row last pin, 2nd row 4th pin, 3rd row 4th pin, 2nd row last pin
5th - 2nd row 3rd pin, 3rd row last pin, bottom row last pin, 5th row 2nd pin
6th - 3rd row 3rd pin, 4th row 2nd pin, 5th row 4th pin, 4th row 3rd pin
7th - 4th row 1st pin, 5th row 1st pin, last row first pin, 5th row 2nd pin.

hope this makes sense!!

Dec 28, 2008 | Nintendo Professor Layton & the Curious...

2 Answers

Cant solve puzzle 100 in professor layton cant go on im desperate


first square is the only one that is straight, all the others are at an angle..
1st - top four pins on left hand side
2nd - top row 3rd pin, 3rd row 2nd pin, 4th row 3rd pin (position 4) 2nd row 5th pin
3rd - 1st row 4th pin, 3rd row 1st pin, bottom row 2nd pin, 4th row last pin
4th - 1st row last pin, 2nd row 4th pin, 3rd row 4th pin, 2nd row last pin
5th - 2nd row 3rd pin, 3rd row last pin, bottom row last pin, 5th row 2nd pin
6th - 3rd row 3rd pin, 4th row 2nd pin, 5th row 4th pin, 4th row 3rd pin
7th - 4th row 1st pin, 5th row 1st pin, last row first pin, 5th row 2nd pin.

hope this makes sense!!

Dec 06, 2008 | Nintendo Professor Layton & the Curious...

Not finding what you are looking for?
2004 kawasaki KX 250 Logo

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6480 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

217 Answers

Are you a kawasaki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...