The front end feels like it wants to wash out

No agitation?

first use a meter and check ur water pressure switch? that is what sends the machine the message to start wash cycle? You can test it with a meter and with a manual test? ( first locate it in the panel, it has a plastic clear tube hose going into it, remove that tube from its connection, now put another small tube or hose into the slot where it was and have the machine set to wash cycle with water in it. Blow into the other end of the tube. If the machine starts to wash. the pressure switch is more than likely good. now take the original hose tube and plug one end and blow into it the other end, it should be hard and have pressure, if it is easy to blow and u dont feel any pressure and it feels like the air is going out ?
sometimes they get busted open or a pin hole and release air causing the water switch diaphram to not open.
If both check ok then next CHECK the motor coupler or belt if belt driven.check with a multi meter for continuity the door switch, and if there is a little movement on wash cycle in 1 direction only then check the cam dogs in agitator.

What is the complete model number of your unit?

I have touchscreen! Doesnt work. Any suggestions? Hate having to get up middle of night to turn off this )%(/₪/#&/₪(" beep!

You really don't want to know, but since you asked......... Remove spring clamp around front of seal by prying under it and peeling it off. The easy part is now done. Peel away seal and stuff it inside drum. Look or feel for screw on clamp around seal thats still attached and loosen clamp screw. Peel seal off and remove. Wipe away any crud on flange. Install new seal starting at the top. Make sure top and bottom of it are perfectly centered. Push seal onto flange all the way around, feeling your way around. Once on and its centered properly reinstall clamp and tighten. If its the flat metal type of clamp do not overtighten or it may come off in wash cycle. Install outer seal to front and reinstall clamp by putting spring on first, wrapping rest of clamp around as much as you can, then holding one end of spring ( I use my knee or you can use small screwdriver) and using needle nose pliers grab other end of spring and stretch it while putting rest of clamp on. Have fun!

unplug it,remove the bottom panel,reach up where the door switch is and at the bottom of it you'll feel a tab,pull down on it and it will release the door.

Remove the filter from the lower front section of the wash tub and clean it out.
Then start a wash cycle with no dishes and no soap.
Once the water fills and starts washing,open the door and pour 1 quart of white vinegar in the wash tub.
Close the door to resume the wash cycle.
Let the machine run a complete cycle to the end to help clean out the water ports.

its the hot water fill velve leaking,,,,your getting a small amount of hot water as well as the cold water when it fills up the washer,,, change the water velve

You can buy rubber pads at the home center that damper the vibrations.
The high pitch noise could be an object stuck between tubs.
WM2277 service manual


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

AT 40oC, I would not expect the door glass to feel hot, but to check if the heater is working o/k, run it on a 90oC wash programme.
The door glass should feel quite hot.
If it it still feels cold after say 30 mins or so, then I would suspect that the heater is not working.
Plz rate my solution.
Thanks.

wash machine not draining properly at end of wash. not fully spinning.
pls advise