Question about 2002 Suzuki GZ 125 Marauder

1 Answer

Remove the starter motor 2002 Suzuki GZ 125 Marauder

How do I get the starter motor out on my marauder 125, I've removed all the bolts etc @

Posted by David Gregory on


1 Answer

Gregg Mahin

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.

  • Suzuki Master
  • 63,710 Answers

Hi, David for this scenario you will need your service manual, parts fiche, and owners manual if you can't find the best tool you ever bought for your Suzuki, despair not, for a mere $15 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
How to remove starter motor motorcycle

Posted on Jul 13, 2019


5 Related Answers


  • 51 Answers

SOURCE: removing starter motor

those are the only fasteners that hold the starter into place. however. on the other side of the starter there is a sealing o-ring. after time this o-ring likes to hold the stater in its place. so with so very light prying the starter should slip out. hope this helps.

Posted on Mar 27, 2009


Johnny Brown

  • 5763 Answers


Okay first remove the neg batt terminal, now at starter remove wiring from rear of starter or wait until starter is loose if more room is needed there are two bolts holding it, remove both bolts and starter comes out, heres a few pictures to help you. i hope this is helpful.fddd88d.jpg8c0b098.jpg

Posted on Feb 19, 2010

tuyen bui

  • 1025 Answers

SOURCE: removing the bolts to my 1998 F150 starter motor

you need to use an extension long enough pass the solenoid so you can put a ratchet on to turn it

Posted on Mar 11, 2010


  • 360 Answers

SOURCE: Dumb question... According to AllData, this is the

Perhaps you're reading more into this than is really there.

The AllData advise sounds accurate, and I'm confident the spirit of the instruction is to perform these initial steps from under the hood (on the top side of the engine). Having completed the initial steps, go under the car and actually physically remove the starter from underneath.

Did you purchase a single vehicle subscription to AllData from AutoZone? The basic subscription is for only one year. For about the same amount of money you can purchase a vehicle specific repair manual and use it until you wear the ink from the pages. I'll take hardcopy over internet any day!

Posted on Feb 08, 2011


  • 461 Answers

SOURCE: hi i want to change


Posted on Mar 10, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to remove starter out of a 1999 suzuki 800

exhaust side of engine back of cylinders. there is a bevelled plate retained bt two small bolts,disconect battery remove plate to reveal starter motor disconect high tension lead to starter. remove two retaining bolts lift starter out from cassing.

Sep 02, 2015 | 2004 Suzuki Marauder 800

1 Answer

2000 be the 800 Suzuki Marauder won't start has juice from the battery but no click at the button or no sound from the starter.

bypass button by crossing the large bolts on the solonoid, it will spark. if starter motor spins you know the buttons at fault take apart and clean

Feb 15, 2013 | Motorcycles

1 Answer

How to replace throttle cable suzuki marauder 125

Hi ! for suzuki marauder 125 cable, please visit the website below. If you need more information about a specific electrical issue you can reach me at [email protected].Good luck and have a nice day.

May 14, 2012 | Suzuki GZ 125 Marauder Motorcycles

1 Answer

How to remove and replace a starter on a FXWG wide glide 1980 Shovelhead harley

To remove the starter from your Shovelhead, first disconnect the battery and take it out of the battery tray. Remove the battery tray, two bolts that bolt to the oil tank and the rubber mounts. Take the battery cable off the starter motor and take the bracket that supports the rear of the starter motor off. The bracket is bolted to the transmission and the rear of the starter motor. Take the remaining long bolt out of the starter. Work the starer out of the starter drive housing. Do not allow the starter motor to come apart as the two long slender bolts that you removed also hold the sections of the motor together. The same when you install the new motor. It will come apart and unless you've got some experience in getting the brush holder back on the armature, it can be a problem. Don't let the motor come apart.

Good Luck

Aug 30, 2011 | 2000 Harley Davidson FXDWG Dyna Wide Glide

1 Answer

How do i deristrict my suzuki GZ marauder?

Won't start 2008 Suzuki Marauder GZ125. The starter switch does not work every time when it doesn't I switch off give it a few seconds try again sometimes it works others it doesn't I try waggling steering sometimes that helps.

Sep 02, 2010 | 2000 Suzuki GZ 125 Marauder

1 Answer

How do you split a yamaha 125 le engine

start at the top of the motor and remove anny guards and so on then there are 4-6 head bolts remove them then remove the transmission and all that. remove the starter and stator and internal coils then you can split the base

Aug 03, 2010 | 2003 Yamaha YZ 125

1 Answer

Will the starter motor off a 125 marauder fit a 125 intruder? I need a starter motor for a suzuki 125 vl intruder, have been offered the starter off a 125 marauder, will it fit? or does any one know where...

Hi, Chrisdol223 pretty sure it will but the answer to this question is way above my pay grade for this situation, I would call or visit my local dealer or reputable shop's service/parts department and inquire about any possible quick fix, answers, or parts inquiry.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Suzuki VL125 Service Manual
OEM parts for Suzuki
Suzuki VL 125LC Intruder
Suzuki Intruder

Btw, I’m available to help over the phone in case u need at

Oct 15, 2017 | 2004 Suzuki VL 125 Intruder LC

1 Answer

Bike wont start

Take out the battery and give it a voltage test. Clean the terminals of the battery. If that won't do, you could take out the starter-motor and get it tested at your dealer's.

Nov 09, 2009 | 2002 Suzuki GZ 125 Marauder

1 Answer

2005 Suzuki GZ 125...cannot get ignition barrel out. Need to replace lock set

hi i am a locksmith you have on the ignition 2x dome head bolts closest to fuel tank the only way to remove the ign is a hammer and centre punch use the punch to tap bolt undone

hope this helps

Jun 15, 2009 | 2003 Suzuki GZ 125 Marauder

1 Answer

How do I get the starter motor off my Yamaha XT 125


There are two bolts going through the starter motor and clutch cover into the crankcase. Undo these two bolts. The only other fixing is the O ring at the front of the motor. You may need to use some penetrating oil here and give the motor a tap with a rubber mallet as water at the front tends to stick these here. The motor should then pull out.

Mar 13, 2009 | 2006 Yamaha XT 125 X

Not finding what you are looking for?
2002 Suzuki GZ 125 Marauder Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

85239 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6394 Answers


Level 3 Expert

858 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides