Got a four wheeler that has spark and getting gas to carb but wont start not sure wat to do i think the valves might be stuck its a beartracker 4 wheeler not sure of the year its says 229cc

Carb could be dirty, float stuck or choke stuck. Pull plugs, crank engine and see if you are getting raw gas in the cylinder(s). If you don't get gas to the cylinders, you won't start. You also could have a flooded carburetor.

Check for spark if it has spark your carb may be dirty or not jetted right if it's not your carb or spark your valves may need to be adjusted

If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

air filter is clogged or you need to clean the carb make sure you have good carb compression and that your gas is running threw the lines properly

is it getting spark? did you check the compression?

not the stator. has to be in nuetral and it could be the solenoid.

Remove and clean the valve coming from the tank

my quad wont start at all it turns over but not getting spark whats wrong with it ??

The valve may be off a bit get the valve specs and check it usually the intake valve that causes that you will have compression but it it will stay open just enough that it won't start

If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

remove all of the old fuel using a siphon bulb and hose. Put in brand new fuel and make sure the line from the tank to the carb. is flowing gas. if not clean or replace the fuel line

first are you getting spark?second are you getting fuel? to check the spark take out the plug and put it back into to cap(holder) do not touch the plug and turn over the engine.you will see a small spark.if not you starter coil is bad.to check the gas look under the carb there will be a overflow hose by the overflow hose is a flathead screw,open it if no gas comes out you will need to take out the carb and replace the float valve.