Question about Suzuki Motorcycles
SOURCE: want to know if suzuki
Hi ....... I don't think Suzuki make an upgrade kit but try Straightline Racing, Harris Performance or EBC themselves, lots of kits available. They'll also be able to advise if it'll fit the gt650.
Posted on Jan 20, 2009
One the left-hand side of the bike (facing forward), there is cover plate just ahead of the drive shaft. Remove that cover (mine has 8mm bolts). The bleeder valve is under this cover. Go to an auto parts store and get a "one man bleeder kit" or if you have some plastic tubing that will fit over the valve, you can use that and a clean jar. Follow the instructions on the bleeder kit, or if you're using the jar and tubing, fill the jar about a quarter of the way with break fluid (use DOT4, but never DOT5!). Take the cover off the master cylinder up at the handlebars, place the tube over the end of the bleed valve (after loosening it a turn or two. Place the other end of the tube down in the break fluid in the jar. Work the clutch lever until you stop getting bubbles in the jar. Be sure to keep the fluid level up in the reservoir. Tighten the bleeder valve, remove the tubing, top off the fluid and replace the covers.
Be careful not to get brake fluid on anything. It will eat paint and mess up other things.
Posted on Feb 13, 2009
I always ride slightly faster than surrounding traffic so I am aware of My surroundings, that time you would take to see how fast youre going is how bikers die often, I learned to check my six or behind me, something I didnt do much until by chance happened to have used a car that night going home from work at midnight and got slammed by a drunk i saw coming but he drove into me anyways!
Posted on Aug 25, 2009
have some push all the way down on the clutch than squeeze the plastic tabs on bushing to release u also need a special tool to remove disconnect the hydraulic line from clutch release cylinder most auto stores carry it or let u use /loan for free
Posted on Oct 31, 2009
Fix A Flat. Screw the needle valve into the noozle of a can of Fix a Flat. Squirt enough in to inflate to normal pressure, Roll the ball around to coat the inside. Blow the needle valve clear afterwards attached to a bike pump.
Posted on Mar 30, 2010
Tips for a great answer:
Dec 12, 2010 | 2000 Suzuki LS 650 Savage
May 28, 2010 | 2001 Suzuki SV 650
May 17, 2010 | 2005 Suzuki SV 650 S
Mar 03, 2018 | 2006 Suzuki SV 650
Dec 19, 2009 | 2000 Suzuki SV 650
Nov 27, 2009 | 2006 Suzuki SV 650 S
Jan 20, 2009 | 2005 Hyosung GT 650 R
64 people viewed this question
Usually answered in minutes!