Question about Suzuki Motorcycles

1 Answer

Why does my 2004 Suzuki intruder 1500 keep backfiring when it down shifts or sometimes when I change gears

Posted by Don buhr on

Ad

1 Answer

Akbar Mughal

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 533 Answers

Change spark plugs.....also check timing is correct or not...

Posted on May 28, 2019

Ad

5 Related Answers

fastboyz

paul erickson

  • 674 Answers

SOURCE: backfiring

when you replaced the exaust you should of had the jetting changed they have to be rejetted.
there is your problem

Posted on Jan 02, 2009

Ad

Anonymous

  • 101 Answers

SOURCE: battery location for a 2004 suzuki intruder 800

Hi ...... Find where the battery is, under the seat or behind a side panel. Disconnect the black (negative lead usually with a 10mm spanner then disconect the red (positive) lead. The battery will be held in place with a 'rubber' strap or a bracket and depending on type of battery there may be a vent hose from the battery to the lower half of the bike, this just pulls off and remains in place until you replace the battery. Installation is reverse except you connect red (positive) first.
Let us know how you get on.

Posted on Jan 20, 2009

Fabrice Wolters

  • 331 Answers

SOURCE: battery removel for a 2004 suzuki 800 intruder

I know for the models till 2002 where the battery is located in front of the rear wheel.

Place the bike on her side stand
remove the negative battery lead at the left side, just below the transmission tube ( cone ) 10mm socket wrench
On the right side remove the security cap on the positive lead ( cross screwdriver ), then remove the positive lead.
The battery is hold in place with a 'floor plate'. remove both bolts of the floorplate ( on each side ) while holding the palte into place.
gently lower the plate and the battery.

I hope the 2004 model has the same assembly!

Posted on Apr 02, 2009

Anonymous

  • 17 Answers

SOURCE: My suzuki intruder is missing backfiring on the

Did you sync the two carbs? If not the rear may be getting all the gas from the rear carb and none to the front. Twist throttle engine off and see if front carb cable is pulling the carb open.
Also unscrew the spark plug boot from the front spark plug wire and trim 1/8th inch off the wire and screw the boot back in. The plug wire end may be corroded on that wire.

Posted on Feb 08, 2010

Joe H.

  • 330 Answers

SOURCE: 2004 Suzuki VL1500 Intruder LC Motorcycle backfire

If they cant duplicate it your good.Usualy with backfiring i would make sure to eliminate any exhaust leaks. The dealer is inexperienced at solving compound problems,(sorry) not picking a fight, but sometimes cleaning is not goog enough,I went through this with a 1400 Intruder.several attempts were needed to get the two carbs level on the same line with each other.so the floats would work properly together,then set fuel flow and the air flow through the ventouri in the carbs.Also i had to make these adjustments while level (not on side stand) The floats were very sencitve to needle valve to seat adjustment(bent to open or close some of the flow)

Posted on Apr 12, 2010

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Suzuki intruder 1500 back fires on decelaration and sputters at half throttle


its fuel injected and mine does the same thing for backfiring. as for half throttle. you closed the choke after it warms up. and might need to check the air cleaner maybe the plugs need to be changed. not sure.

Jul 31, 2014 | 2004 Suzuki Intruder LC 1500

1 Answer

Bike stops accelerating in 4th gear and slows down sometimes


thats a puzzle. hope you haven't sheared the teeth on 4th gear.

Apr 21, 2014 | 2004 Suzuki VL 125 Intruder LC

2 Answers

I have Suzuki VL 1500 Intruder bike. The clutch keeps dis-engaging and not operating right. Any ideas


http://www.bikebandit.com/2004-suzuki-motorcycle-vl1500/o/m6819#sch502265

Here is a schematic, parts list, and prices for your 2004 VL 1500. Friction disks wear out and have to be replaced at regular intervals. Clutch slipping is almost always remedied by replacement of the friction disks.

Dec 07, 2010 | 2004 Suzuki VL 1500 Intruder LC

1 Answer

Suzuki Intruder 1400 1996, First to Second Gear is harsh!


Change the fluid in the clutch reservoir,bleed out the remaining fluid.(keep it full as you go) Should be dot 4 fluid not dot 3. U may need to rebuild the master cylinder or replace it.

Apr 24, 2010 | 1996 Suzuki VS 1400 Intruder

3 Answers

2004 Suzuki VL1500 Intruder LC Motorcycle backfire


If they cant duplicate it your good.Usualy with backfiring i would make sure to eliminate any exhaust leaks. The dealer is inexperienced at solving compound problems,(sorry) not picking a fight, but sometimes cleaning is not goog enough,I went through this with a 1400 Intruder.several attempts were needed to get the two carbs level on the same line with each other.so the floats would work properly together,then set fuel flow and the air flow through the ventouri in the carbs.Also i had to make these adjustments while level (not on side stand) The floats were very sencitve to needle valve to seat adjustment(bent to open or close some of the flow)

Apr 12, 2010 | 2002 Suzuki VL 1500 Intruder LC

1 Answer

Suzuki intruder 1500 charging system


You need to buy a volt meter and set it on 10, or 20 v-. Start the bike and see what it says. A good charging system will show 13-14+ volts. If the meter says 11-12 volts or does not change, you have a bad stator, or rect/reg. Take to a shop to have it further tested. Chaz Moto DC

Jan 22, 2010 | 2000 Suzuki VL 1500 Intruder LC

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6523 Answers

Gino Cussen
Gino Cussen

Level 2 Expert

217 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...