What is the point gap mmon a 1982 Suzuki 3.5HP DT outboard?

1985 DT75 torque settings

Suzuki Outboard Forum https://www.suzukioutboardforum.com > forum > 589...
Apr 28, 2017 · 3 posts · 2 authors
1985 DT75 torque settings ... I've found out the torque pattern for the head is on the head but what do you torque the head bolts down to? only ...
torque specs? - Suzuki Outboard Forum
9 posts
May 31, 2012
DT30C tech questions - Suzuki Outboard Forum
5 posts
Jan 17, 2013
torque specs - Suzuki Outboard Forum
11 posts
Jan 23, 2017
DT-55 Water in middle and bottom cylinder?
15 posts
Aug 17, 2014
More results from www.suzukioutboardforum.com

need your serial number please

1986-87

https://www.brownspoint.com/store/pc/pdf/DT75_85(86-87).pdf

Page 3
#6 Engine Number

Have tried manualslib.com?

Hey Rolin,
..could this be a brass tube? It probably a vent tube..it should not be bent or crimped...

http://www.championbrands.com/aera-torquespecs.pdf

Try this link. It should have the torque specs.

.028"

Have you checked the kill switch,make sure all earths are grounded

There are points on it if it is the one I am thinking it is by the picture. 1978-1982 ish? They should be located under a five inch or so round cover on the right side of the engine, just infront of the rear brake pedal. Be carefull removing them, there is a special tool to remove the plate the is in the back of them. Just make sure they are not rusted and check the gap on them ( I would tell you what the gap is supposed to be, but I don't know).

gap is approx 12-15 thou/ but if running points can vary trgoing over to cdi?