SOURCE: adjust clutch cable
If you have a stock cable you need a 9/16 and a 1/2 in. wrench. about 1/2 way downn the cable there is a rubber boot. pull the rubber boot over the adjustment. Loosen the liock nut and adjust the cable so you have aprox 1/8 to 1/16 in. slack in the handle. Re tighten the lock nut and pull the rubber back over the adjustment.
SOURCE: oil change 1999H D Electra glide
The plug ( 3/4 wrench ) under the trans when your looking at the trans cover ( right side of the bike ) is the trans. If you drained that replace it with 24 oz. of either HD trans fluid or I prefer Golden Spectro 75/140 ( much better shifting on a Harley ( trust me you'll never go back to HD trans fluid ) the drain for your motor oils is on the same pan ( on the bottom ) but it's the plug facing the front of the bike. Looks just like the trans plug. Both use a 11105 o ring which you should replace everytime ( just for piece of mind as well as leaks ) you need 4 quarts of 20/59 HD oil. Hope it helps.
I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_5bac37c3cb991fdb
SOURCE: Went to change the oil on my 2002 electra glide ...nadda oil
are you sure you didnt drain the primary case oil they usually hold a little less than a quart.. dont run it until you make sure or you could burn clutch and primary chain up.
SOURCE: I JUST NEED THE OIL CAPACITIES AND TYPE FOR A 2002
Oil change without filter 3.5 quarts
Oil change with flter change 4.0 quarts.
Primary 1 quart.
Transmission 20-24 oz.
Very important check your fluid levels afterwards refilling to make sure you have correct level of fluids. Hope this helps.
JP
SOURCE: I keep blowing the accessory fuse on my electra glide
I'd say that you have an intermittant short somewhere. These are very difficult to find. I'd start at the tail light assembly as most of the time, I've found the shorts in that area, from the seat back to the tail light assembly.
Good Luck
Steve
33 views
Usually answered in minutes!
×