Question about 2008 Harley Davidson FLHTCU Ultra Classic Electra Glide
SOURCE: cant find the battery
Under the tour pak on the rear fender is a screw which you have to remove then you can lift the seat out from the rear end. When replacing the battery wrap a thin strap of leather or canvas around the battery and this will allow you to lift the battery out a lot easier the next time.
Posted on Mar 06, 2009
Not too hard - Undo the two bolts on the caliper and then seperate the caliper and pull the old ones out. Insert the new ones and put the bolts back in to hold the caliper back together and then install them back on the bike with the two retaining bolts. Use a bit of lock tight (Blue) on the threads. Warning do not let anyone apply pressure on the brakes while you have them off the bike or you will have a mess and/or a problem.
Posted on Jun 21, 2009
Sounds like your charging system is not charging the battery.
Put a volt meter on the battery, run the engine up to maybe 2,000 RPM. The voltage must be at least 13.8V, but not more than 14.5.
If that is all OK, your battery is worn out, and is not holding sufficient reserve. It would need to be replaced.
Posted on Jun 23, 2010
Testimonial: "waiting on dealer to get back to me...voltage meter on bike reading between 14-16"
30 psi in the front and 36 in the rear for single rider. Two up riding, raise the rear tire to 40 psi.
Good Luck and Ride Safe
Posted on Aug 16, 2010
Tips for a great answer:
May 07, 2014 | 2000 Harley Davidson FLHTCUI Electra Glide...
Sep 29, 2012 | 2008 Harley Davidson FLHTCU Ultra Classic...
May 23, 2012 | 2008 Harley Davidson FLHTCU Ultra Classic...
Aug 11, 2011 | 2002 Harley Davidson FLHTCUI Electra Glide...
Jun 23, 2010 | 2000 Harley Davidson FLHTCUI Electra Glide...
Jul 27, 2009 | 2000 Harley Davidson FLHTCUI Electra Glide...
Usually answered in minutes!
Step 2: Please assign your manual to a product: