Hi guys I have a Suzuki 175 with fly by wire that all of a sudden started to beep every 3 to 4 sec and now won't go into gear

Hi
Are you sure that's not a 'safety feature' to warn others that you're reversing - like on commercial trucks?

Also, why do you let it warm up for 10-15 mins? Seems excessive? Is this suggested in the Owner's Manual for that engine? As this is surely fuel injected, it should be ready to go immediately....or wait ~5 minutes if you're going full throttle from the dock/launch...to let the oil warm a bit.

GL,
TD

Start by looking at the fuse box... check all the fuses. Next possibility is a relay.

The Suzuki Jimny Transmission Control Module (TCM) is an electronic circuit component that controls gear shift, TCC lock-up and idle-up according to the signal from each sensor. It is a microcomputer consisting of an IC, transistor, diode, etc. It is installed behind glove box.

1. Ignition switch
2. Transmission range sensor
3. Input shaft speed sensor
4. Output shaft speed sensor (A/T VSS)
5. Shield wire
6. Vehicle speed sensor (VSS)
7. Transmission fluid temperature sensor
8. Shift solenoid-A (Shift solenoid No.1)
9. Shift solenoid-B (Shift solenoid No.2)
10. Shift solenoid-C (Shift solenoid No.3)
11. Shift solenoid-D (Shift solenoid No.4) 12. TCC solenoid (Lock-up solenoid)
13. "O/D" cut switch
14. "O/D OFF" lamp
15. Monitor connector No.2
16. DLC
17. To ECM
18. To A/C
19. To brake lamp switch
20. To main relay
21. Terminal arrangement of TCM coupler

Clean fuel line

Hi there? it sounds like the battery is flat ( discharged ). get sumone to givethe car jump start or have the batery recharged or replaced. Good luck

Sounds like memory. If you have more than one stick of memory, try using 1 stick at a time and see if it will boot.

find button with lock emblem hold 3-5 secs if will not clear suspect either bad interface(buttons ) or bad connection or broken wire between front panel and interconnect on main control

Beep Codes:

click this link: http://www.intel.com/support/motherboards/desktop/sb/cs-010249.htm

more than likely its a ram problem