What is the head bolt torque spec for a 1994 Honda ct110

SOURCE: Head bolt torque specs needed for 96 tbird 3.8

Head bolts are torque to yeild so you MUST use new bolts.
Tighten cylinder head retaining bolts in numerical sequence in three steps as follows:

1. 20 Nm (15 lb-ft).

1. 40 Nm (30 lb-ft).

1. 50 Nm (37 lb-ft)

• Tighten to 40-50 Nm (30-37 lb-ft).
• Rotate an additional 175-185 degrees.
• Go to next bolt in sequence.

• Tighten to 20-30 Nm (15-22 lb-ft).
• Rotate an additional 175-185 degrees.
• Go to next bolt in sequence.

SOURCE: head bolt torque spec

Always use new head bolts.
1)tighten to 40ft/lbs
2)back off 1/2 turn
3)tighten back to 40ft/lbs
4)tighten an additional 90 degrees
5)tighten an additional 90 degrees.

SOURCE: 94 mazda B3000 3.0L cylinder head torque specs

Step 1 torque to 59 ft pounds
2. Loosen one full turn
3. 37 ft pounds
4. 68 ft pounds

Use torque sequence below

SOURCE: what are the head and rod bolt torque specs on a

one hundred ten inch lbs on the rods and 45 ft on the head bolts

SOURCE: need torque specs for 1994 ford escort 1.9 ltr

Torque new cylinder head bolts in sequence to 44 ft lb. Loosen bolts approximately two turns, then torque bolts in sequence to 44 ft lb. Turn bolts an additional 90 degrees in sequence, then an additional 90 degrees

Torque sequence
9 3 1 5 7
8 6 2 4 10