What about the immobilizer and ignition control module or ECM
guessing wastes money so have the fault codes read first and then fix the problem area
SOURCE: 1998 hyundai accent
make sure crank sensor is all the way seated care taken 10mmnut dont over tighten or you will break sensor
SOURCE: I can NOT GET SPARK
You don't mention the spark plug leads. We had the same problem and found it was a cracked lead. However, WE now have a problem! We took the leads off to get new ones and have lost the diagram we made showing which lead goes where - can you help?!
SOURCE: my engine shuts off while im driving
Check ecm for number 1228253. If it has this one in it you will have a cutting off problem. Gm replaced these with #16198264 The cam sensor magnet on the cam gear will deteriorate and give problems. This will require removal of the timing cover.
SOURCE: cranks and no spark no power at coil pack
i believe this line is fused from the E.C.M.,go to your local library and find a chilton's auto manual,this will tell you for sure
SOURCE: 2003 chev malibu wont start due to lack of spark
That car has 2 crank sensors , did you replace both? One is at the front crank pulley and the other is behind and low on the engine block, above oil pan. Be sure the ICM (ign control module has a good ground, (black wire) it grounds at a bracket where the trans bolts to the engine approx at the 2 o'clock position.
Testimonial: "the check the ground was a good suggestion, i will do that at my first opportunity"
69 views
Usually answered in minutes!
×