SOURCE: Float setting for BS34ss carb
I have a set my float to 22.0 +- 1.0 for a Mikuni carb.
To set floats, drain the carbs, pull the carbs from the bike invert and remove float bowl.
With the carb inverted, take off the float bowls. Take off the gasket. Use a vernier caliper or an accurate device to measure from the carb body to the top of the float block.
Here is are a couple of good sites about carbs and such.
http://www.allthingsmoto.com/forums/f-15/how-set-your-motorcycle-carburetor-float-level-more-commentary-13608/
http://www.dansmc.com/carbs2.htm
SOURCE: float height 1996 gsx r750T. Where exactly on the
you put it on the float base and allow the float to drop down and read the gauge where the float is read the top of the oppiste side where the float is hinged.
SOURCE: floats not set
Float tabs come set flat to surrounding plate, bend up to decrease level and down to raise level. Raised level too much and you risk fuel overflow on sustained inclines and too low a level and you will lean out at high revs and damage valves/piston real quick. There is no set level to speak of, but better to err on the side of losing a bit of overflow. The overflow drains from the carby via a plastic hose from just above float bowl flange.
Cheers.
SOURCE: KDX200 carb float set up. Hi I have gas coming
my 1998 KDX200 is acting like it isnt getting gas what do i do ?
104 views
Usually answered in minutes!
×