Stalls out when I put it in gear..when I rev it to about 7000 rpm and put it in gear its fine until the next day and It does it all over again?
SOURCE: The battery on my 1995 Yamaha Virago 250cc is not working
starter brushes could be worn out or a dirty or loose connection!
Starter button may need checking also the solenoid
week compressin or leaking diaphrams in carbs will cause it too
I suggest you charge battery & start at the button & work your way back
SOURCE: 02 yamaha vstar 1100, ran fine. started it the
Sounds like it may be drawing air around the intake somewhere. Let it idle and spray around carefully with wd-40 until it speeds up. This will reveal the leak.
SOURCE: i have a 1986 yamaha virago 700 that wont run properly
2 things need to be done first start your bike get a can of wd40 after your bike is warm and running spray around the carb jointsall 4 of them if your engine changes rpms up or down you have a intake leak ether your carb joint gaskets or o-rings need replacing or your carb joints are old and need replacing. at this point wont hurt to have you carbs cleaned also
SOURCE: Virago left on PRI and now won't start...
Check your oil level. If your carburetor overflowed and filled the engine with gas you may have fowled your air filter with oil/gas. If your level is too high you will have to change you oil. Also check your air filter to make sure is is not gas/oil fowled it may need changing.
110 views
Usually answered in minutes!
×