I am trying to replace the indicator bulb and i am having trouble getting old bulb out

Most hazards flash brake lights not the turn signals, double check your signal bulbs. Try to get it to flas fast and visually inspect which bulb isn't working. Then replace that bulb

Some lights won't let you replace the bulb. You will probably have to replace the bulb and the casing. Take the entire casing to your nearest auto store and they should have what you need

Hello,

A red or pink tint on LCD monitors indicate that the back light florescent bulbs are about to go out. Just like on regular florescent these bulbs are just much smaller but burn out just the same. Check the date on the back of your monitor, if it is less than 3 years old then its still under warranty but if its not then its time for a new monitor. The bulbs can be replaced but it really is not worth the trouble.

My mother's car was doing the same thing. The trouble ended up being the electrical connector on the bulb. It was not making contact with the plug. Once I replaced the plug the problem was corrected. The super low lights could have been due to the fact that the other bulb was not on. Try checking the connection and if that is the trouble, replace the plug if possible.

should be 1 silver phillips head screw on the corner light housing where the housing meets your front headlight housing. once you take that screw out, pull the corner light housing straight towards you, like towards the nose of the car, unclup the harness for the light bulb and your good to go

The ballast for the lamp too should be replaced along with the lamp. If you wish to get some details; visit the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/

It is a sealed unit. Either it will unplug from the back and you will maybe have to twist it a little..gently. Or you will have to replace the whole unit..go to your local auto parts store and go to the parts counter and ask that good looking guy or girl behind there for assistance..Peace

the bulb hot indication has nothing to do with the lamp counter.u would have reset the counter as suggetsed by the manufacturer,
this problem is because of the following:
1) wrong bulb
2) cooling fans not working adequately
3) defective ballast
check the above for a solution

There are two black plastic clips behind the the air filter, remove them and release the whole assembly to access the lights.

If you still get in troubles, have it replaced at a petrol station, they will help you in fitting the bulb, and it won't be expensive.


Here follows
2003 Chevrolet Tracker Light Bulb Size Chart
Low Beam Headlight Bulb Size: 9003/HB2
High Beam Headlamp Light Bulb Size: 9003/HB2
Parking Light Bulb Size: 1157A
Front Turn Signal Light Bulb Size: 1157A
Rear Turn Signal Light Bulb Size: 921
Tail Light Bulb Size: 7443
Stop Light Bulb Size: 7443
High Mount Stop Light Bulb Size: 168 Or 921
License Plate Light Bulb Size: 168
Back Up Light Bulb Size: 921
Front Sidemarker Light Bulb Size: 194
Ash Tray Light Bulb Size: 74
Step/Courtesy Light Bulb Size: 168
Trunk/Cargo Area Light Bulb Size: 168
Instrument-General Light Bulb Size: 158 or 74
Check Engine Indicator Light Bulb Size: 74
Hi-Beam Indicator Light Bulb Size: 74
Seat Belt Indicator Light Bulb Size: 74
Brake Warning Light Bulb Size: 74
Automatic Transmission Indicator Light Bulb Size: 74
Directional Signal Indicator Light Bulb Size: 74

the ballast or the DMD are the only other two possiblities. you will need to trouble shoot if you would like a link to the service manual let me know, they email it right after purchase and offer free tech support.