SOURCE: oil change light
Turn the key on. Observe the odometer. Is "ODO" displayed? If not, push the trip meter button until "ODO" is displayed, with the total mileage travelled shown.
Turn the key off.
Push & HOLD the trip reset button until advised to release it.
Turn the key to "ON" (do not start engine)
Observe the ODO display.
You should see 5 dashes, then 4, then 3, then 2, then one, and finally, five zeros.
The original mileage that you observed should be redisplayed.
Release the trip reset button.
The proceedure is now complete.
SOURCE: oil was changed and check engine light was not reset
This is really easy! Please follow these directions:
Turn the key ON
Look at the odometer, and verify that it displays "ODO" and the total mileage traveled. If it is on "Trip A" or "Trip B", press the black stick next to the odometer to read "ODO", and the total miles traveled.
Turn the key OFF.
Press in, and HOLD the black trip meter reset button, hold it in.
DO not release it.
Turn the key ON; do NOT start the engine
Observe the Odometer display. The total mileage traveled will disappear, and you will see 5 dashes, then 4, then 3, then 2, then 1 dash, and finally, 5 zeros. Then, the total mileage traveled will redisplay.
Release the black trip meter reset stick.
This completes the reset procedure, and the light will be back on in 5,000 miles, to remind you of you next oil change.
Hope this helps, and thanks for choosing FixYa. Happy Thnkasgiving!
SOURCE: LEXUS LS 2004 Maint Reqd (Master warning light)
You can disconnect your battery for 15 minutes or pull the fuse for an ECM or PCM fuse, but the best way is to visit any local repair shop. Most shops will have a universal Check Engine Light Code Reader that can quickly and safely reset check engine light trouble codes. It should take about 30 seconds.
Ask your local service center if they could reset the check engine light with a Check Engine Light Code Reader.
SOURCE: Change Oil Warning won't go away.
Depends on model and features. 2009 SEL, with no rear seat entertainment:
Place ignition in "Key On, Engine Off" position, then push gas pedal to floor and release 3 times. Turn ignition off, and it should be reset.
The procedure was in the owners manual in the section about the odometer and related features.
SOURCE: how to reset timing belt
if it has a digital odo/ press trip knob until odo is displayed/ press and hold , turn ignition , hold for 4 secounds , release and press again, number 10 will be displayed, keep pressing until 20 comes up, press until odo reading is displayed again, turn ignition off , turn on again , notice the t belt lamp turn off in appros 5 secounds / if not able to reset try this again
746 views
Usually answered in minutes!
×