At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
https://www.amazon.com > Suzuki-GSX600F-GSX750... The Cyclepedia.com Suzuki GSX600F GSX750F Katana Online Service Manual features detailed full-color photographs and complete specifications with ...
Usually found under the front (engine side) of each carb and requires a special (long and 90 degree) screwdriver to adjust when fitted. Most people have to remove the carbs to access the screws.
http://www.totalmotorcycle.com/buyersguide/Suzuki-GSX750F-Katana.htm
It shows that this bike has 93 horsepower, but you can check out that link and see more info on the bike. Let me know if this helps you out, Jeff from FIXYA
by adjusting the air mixture screws turning them out by quaurter turn at a time on the carbs but before you do that check to make sure your air filter isnt clogged because that can cause the same problem as well as poor fuel consumption
hope this helps
hi,this might help,it is very difficult to get the adjustments right without a set of carb balance gauges,the adjustments are very small and critical to the running of the bike,borrow or buy a set of gauges,hook up the gauges,balance the left two cylinders together so they are both running exactly the same,then do the two right cylinders and get them both running the same,then match the two sets together using the balance screw between no2 and no3 cylinders,a general rule of thumb to get a startng point is to wind the mixture screws in untill they stop,then back them out about 1.5 turns,do the same to all four screws before you start trying to balance the carbs,make sure the bike is sitting vertical or on the centre stand because if it is not it will effect the balance of the carbs and also make sure you have a good airflow over the front of the motor for cooling as it will take half to three quarter of an hour to get the balance right...most bikes need the carbs rebalanced on a regular basis because when the parts of the carbs start to wear the balance will change,a good set of carb balance gauges is a worthwhile investment...hope this helps
You have to sync thecarbs and also you will have to reset the air-fuel mixture screws.
One of the carburators should be factory adjusted, I dont wn a kawasaki but I own a YAMAHA SECA XJ750R and thro it I am sharing my experince.
Once you have located the factory preadjusted carburator you can thn set the others to its specs. I use the feeler gauge to do for my bikes carburators and it works fine.
With regards to the mixture screw..... get the all in tightened but slowly aas to not damage the pin end of it!.
Start the bike and get it to normal running temp and thn set the screws 2 and half turns out...you may need to set your idling speed before you begin this setting of the mixture screws, you prolly will hveto go higher on revs or vicecersa ....onc eyou are at the mixture screws and adjusting them , you will surely note the differenc ein sound of he bike an its idling ..
Hope this will help.
×