Http://elektrotanya.com/zanussi_zwh_6120p_wiring_diagram.pdf/download.html
looking at the diagram for the machine
i see the line door this is used to turn on and off the motor
i think if the heating element fails or one of its fuses {prob a bad element} then the machine will stop half into a cycle because it cant heat up
so it will just stop dead
its not a very intellegent machine so i expect no error codes etc
hope im right and its the heater etc... as it makes sense if you look over the diagram at the link above
you should check the NTC and also the level sensor isnt jammed open you may need to replace it
it wont fill either if the heating element is open circuit
×
SOURCE: Zanussi turbodry 1050
this may sound silly but check the waste outlet pump electrically, some models are wired up so if the pump fails the water will not enter the machine, this works on the theory that if it fills up it can not empty also check the solenoids for open circuit electrically, double check the water supply to the machine, it may have been fine but you could have kinked the pipe placing the machine back where it should go?
SOURCE: washing cycle light won't stop blinking
The filter might be clogged. If you haven't found a fix or answer yet -it's been 2 days :o) There are two screws on the bottom panel, take it off, unscrew the round cap in the middle (make sure you have plenty of towels) and check the filter.
SOURCE: zanussi washing machine wont spin
check the drain hole when you start the machine if the water is coming back out , if yes that means your dump valve is bad.
SOURCE: wash cycle and spin
you need to check a simple button called " no spin" may you will see it marked "aspiral shap" and has "x" over
good work !
200 views
Usually answered in minutes!
×