Iinstalled the tour pak,it has lights on both sides of the truck and light mounted on the rear of the trunk, I need the instruction on how to wire them up to work.
If you bought the lighting kit from HD you should have instructions coming with the kit. If not or you lost them a Harley dealer either service advisor or parts person can print them off for you. If you have the tour pak and it is already wired then all you will need to do is route the wiring harness and connector out from the front of the tour pak to the area under the seat and connect it to the existing rear lighting connector. If it is not fully wired you may have to purchase necessary harness extension(s) and connector pieces from a Harley Dealer. Of course you could splice into the existing harness and solder the wires together but if the tour pak is quick removable this would make it difficult to remove it as it also would if it is not a quick removable installation type and for some reason you had to remove it from the bike at any time, so in any case you will likely be better off to use the correct harness extension and connectors etc.
SOURCE: connect Ultra tour pak wiring on 2005 FLHRSI
Your Tour-Pak lighting kit includes connectors and directions specific to your bike on where to connect. Please refer to those instructions for granular detail.
SOURCE: wiring diagram for tourpak on 2003 Harley Road King Ultra Classic
i have a 2003 ultra classic my riding lights keep blowing the fuse it wont do it sitting in the garage i have gone thru the wiring harnessing looking for the short fixed many things but still have the problem the turn signals work the brake lights still work so where do i look
373 views
Usually answered in minutes!
×