Question about 1988 kawasaki ZX 400
What is the Kawasaki zx400G floats height settings @
Posted by Anonymous on
you put it on the float base and allow the float to drop down and read the gauge where the float is read the top of the oppiste side where the float is hinged.
Posted on Aug 23, 2009
YOU CAN ADJUST FLOATS WITHOUT SPECIAL TOOLS. ALL YOU NEED IS A FOOT LONG PIECE OF CLEAR TUBING, SIZED TO FIT THE BOWL DRAIN. SET FLOATS AS CLOSE TO WHAT THEY WERE WHEN YOU REPLACED IT. INSTALL THE BOWL AND PUT THE TUBE ON THE DRAIN. OPEN THE BOWL DRAIN SCREW WHILE HOLDING THE TUBE UP BESIDE THE CARB. WHEN YOU GET THE TUBE BESIDE THE CARB ASSY., THE GAS IN THE TUBE SHOWS YOU THE EXACT LEVEL OF FUEL IN THE BOWL. FROM THIS YOU CAN MAKE ANY ADJUSTMENTS NECESSARY FOR CORRECT LEVEL. THE LEVEL SHOULD BE RIGHT BELOW THE PLANE WHERE THE BOWL MEETS THE CARB BASE.
Posted on Oct 22, 2009
SOURCE: Float height setting
Back firing is normally an electrical problem. The carb is sometimes adjustable but needless to say, it doesn't go out of allignment on its own, so bear that in mind when trying to eliminate the carb. If it is choking when ticking over, check the idle jet setting.
Posted on Dec 08, 2011
Tips for a great answer:
Jul 16, 2010 | 1999 kawasaki ZZR 600
86 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: