1992 Honda CB 750 Nighthawk firing order

SOURCE: 92 honda cb 750, oil light will not go out, bike won't start

Look around the engine oil drain plug and fill area and see if there is an electric sending unit( small plug with a prong for a wire) that is screwed into the engine if so check to see if its unplugged / could be a low oil cut off switch that kills all power to the ignition if the oil is to low ( or the wire is unplugged)

SOURCE: where is the idle screw for cb nighthawk 750

follow your accel cable to the carb. move the throttle till you see where the linkage moves. look around the linkage to see what it hits on at no throttle. that will be your idle screw

SOURCE: both cylinders firing below 2,500 rpm. past that,

My bet is on the CDI

SOURCE: I just purchased a 1982 Honda Nighthawk 750 and

The battery is accessed by removing the right side cover. Just tug gently on each corner and it should pop off. To remove the seat, locate the two bolts, one on each side near the rear of the seat. With the two bolts removed, lift the seat up and back to remove it.

SOURCE: 1992 honda nighthawk 750 wont stay on and when i

sounds like you have to clean out the carbys. you should be able to at least drain them without taking them apart.