Question about 2008 Jonway yy1505

1 Answer

My 125cc twist and go scooter's number plate started melting

When I switch off the bike, there is a ticking sound going fast and then slower til it stops. Recently after driving for a few kilometers I noticed my registration plate looked like it burned or melted on the right lower corner, that's on the exhaust side. The Scooter is a MotoMia twist and go 125 cc. (That make is not listed in the list, but is basically the same than any Chinese scooter like Johnway, etc)

Posted by Kobus Myburgh on

Ad

1 Answer

Matt Weaver

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 665 Answers

It sounds like it might have the wrong exhaust or muffler. Check all clearances and any plastic parts that might be too close.

Posted on May 29, 2014

Ad

1 Related Answer

wadingriver

wadingriver

  • 2223 Answers

SOURCE: I have a Jonway 50cc scooter. The problem I am having is I turn the key. The fuel guage goes up. As soon as I apply brake and press the starter the gas guage goes down. I hear a ticking sound. What is

sounds like you overfilled it with oil

Posted on Oct 26, 2012

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My speedo RS125 2007 has been broken for a few


Wait for new one to be installed before selling. The more you drive it, the bigger will be the error on the odometer miles. You will have to mark the title as incorrect milege if the new buyer notices the broken speedo. Wait, fix it, sell it.

Aug 27, 2014 | Motorcycles

1 Answer

I have a singer 247 it was sewing really good but started going slower and slower til it stopped could it be the motor


It is more likely that a bushing internally warms up then seizes partially. A good cleaning and lubrication could solve this. To test the motor remove the drive belt and run the motor with no load, see if it slows down if not see idea above.

May 13, 2014 | Singer 7462 Mechanical Sewing Machine

1 Answer

Please stop telling people Rolex watches don't tick.


Yes, absolutely correct , all automatic watches tick and the fake Rolexes just tick a bit slower so it is more visible.

Oct 08, 2012 | Rolex Watches

1 Answer

High idle on HD, 08 Road King Classic


For fast RPM's at start that doesn't go down shortly after starting.
1) Put bike in neutral
2) Push to ON the first switch to right of starter switch next to throttle.
3) turn dial on gas tank to the On position for 5 seconds then off wait 2-3 seconds and repeat 3 more times total of 4 times
4)then Turn everything to off positions
5) wait a few seconds and start normally

I found that if you shut down the bike with rpms up a bit, it will start the next time with a faster than normal idle.

If you do this technique when the bike is cold, it will run a little fast til it warms up. Don't ask me why this works.

Jun 05, 2012 | 2008 Harley Davidson FLHRC Road King...

1 Answer

I sometimes have upperend noise while idling, a tick tick tick noise, then gradually fades to a less noticeable sound. The bike has, 3,800 miles on it and had sat for a few years prior to my buying....


Have the valves adjusted. A ticking sound on the top end is almost always the valves tapping. I slight ticking sound is normal but if it's been sitting for a while it's good to have them measured anyway.

May 11, 2011 | 2000 kawasaki ZR-7

1 Answer

Actuaaly lemans 11 but problemis: bike starts first turn runs sweet and will tick over fine. Will tick over 5 or 6 times on either cylinder. Ride the bike for a few kilometers and it starts to feel a bit...


Has the bike been standing along time? if so its probably the pilot fuel tunnel in the carb blocked. replace the pilot jets and main jets and soak the the carbs in a good carb cleaner.

Feb 18, 2011 | 1985 Moto Guzzi Le mans III

1 Answer

Suzuki GSF400 Bandit problems with tick over.


as you have replaced carbs you will need to retune for fuel intake also check its getting enough air ie.. air filter has been changed or is clogged

Jun 16, 2009 | 1992 Suzuki GSF 400 Bandit

2 Answers

Tick In motor every few seconds after intake gasket changed


Sounds like when they did the intake,They drained the fluids but forgot to fill them back up and since the oil was near empty,I would say it's a lifter.But they can be reprimed or replaced a whole lot easier than some other possible causes.

May 14, 2009 | 1998 Ford F150 Regular Cab

2 Answers

2003 Mitsubishi Montero (full-size) check engine light is on, the engine sounds like it knocks as I accellerate and the shift diff. lights blink after driving 25 or 30 miles.


The engine is probably making a knocking sound because the oil needs to be changed or replaced. The check engine light is indicating that you will need regular dealership servicing soon, however you can still drive the vehicle but depending on mileage it will determine what services are required.

Mar 17, 2009 | 2001 Mitsubishi Montero

1 Answer

Good Signal, Good Speed, Slow Internet?


Try plugging the computer straight to the router.If all is well the adapter may need a firmware or driver update.Or your adapter may be experiencing some type of heat problem or failingRICHARDM69

Nov 29, 2008 | Linksys WUSB54GSC Compact Wireless-G USB...

Not finding what you are looking for?
2008 Jonway yy1505 Logo

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jonway Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6375 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

32921 Answers

ray gallant

Level 3 Expert

68239 Answers

Are you a Jonway Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...