I need to change the bulbs in the over head panel and can not remove it

If there's no screw heads outside, it only means they are accessable from inside the trunk by removing the carpeted panels that just pull out. Don't pull too hard and break or bend them. The bulb is inside a housing you have to twist and pull to get to the bulb. Remove the bulbs and put the new ones in.

please use chelton manual for getting instructions with diagrams.

remove the side screws and then remove the rim of the light

now you can access the lights

remove the headlight is easier ,in the back of the access panel if you can get to it is a spring clip well you sort of push this down and sideways on one end ,use a mirror and you will see what i mean ,not the screws though they hold the bracket the clips is on

it's only 15 minutes work, open the hood and locate a bolt (8 or 9mm) back of the head lamp, remove the bolt and pull the head lamp and if you need to change the bulb, remove the bulb by turning clockwise and replace with the new one. hope it can help you...

You don't have to remove the headlight to change the bulb. The bulb can be removed from the back of the headlight, usually by turning the bezel ring that holds the bulb onto the headlight housing. Just make sure you do not touch the glass part of the bulb while replacing it or it will burn out again fast.

To replace the headlight bulbs.You need to remove the head light assembly out.The head light assembly is held by 2 to 3 three screws on each side. You need to remove those screws first.The front trim will get loose,the front trim is held by pins.The pins are of plastic and easy to release.Just release this pins and the front trim will get completely loose and can be easily taken off/. The head light assembly is in the front fender.Once the front trim is removed the head light assembly can be easily removed from front fender compartment.If its bit tight there,then you can use a screwdriver to give it a pull towards out.The head light bulbs can now be easily seen as well as easily removed now.Turn the bulb socket counterclockwise to remove the bulb from the bulb assembly. -------- Keep updated for any more queries.Thanks.

The bulb located adjacent to the shifter has burned out.
It is easily accessible. Remove any visible screws, including opening the glove/storage lid and removing the screws in there. Once all the visible screws have removed, the panels snap off.
Did a bulb change-out on this exact problem/exact vehicle recently. It took less than 30-minutes from Start to finish. You only need a Phillips head screw driver and a Flat head screw driver for prying the panels off.
TIP: Take the bulb with you when finding a replacement to ensure you get/receive the right size and type. There will be an the bulb or on the base of the bulb a set of letter and numbers telling you the particular bulb you need.
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!

you need to remove the front bumer and you will see the head lamp bolts remove them and your headlamp unit is free as a bird.

you need gloves hands cant touch bulbs .oils from hand causes bulb to blow.to change bulb you raise hood remove head light housing has to be removed before you remove bulb.

u have to twist the harnes that keps the bulb in and ull be able to remove the bulb ... the tail lights u have to remove the platic caps and the break light panels have to come out hope this helps