At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Try this:
Turn kill switch to ON/RUN position.Cycle the ignition(key) switch 4 times (each time long enough for engine light to go out ~15 seconds).
This resets the "zero" position of the Throttle for the ECM.
The problem is that over the winter water tends to condense inside the fuel tank. If you did not replace all of the remaining fuel from the tank it might be contaminated with water. Try to leave your bike with a full tank next time you live it unused for a long time.
could be the tail lite housing. or the ground on the frame rail back near that location. remove the assembly till its hanging by its wires and remove the bulb. using a test lite probe the socket with the flasher on see if it blinks. if not go down under the rear of the truck and unplug the connector for both tail lites and do the same probe each connector on the harness that goes forward till your test lite starts to blink if it does there then the tail lite assembly is bad if not then repost and ill lead you further
I would be talking to the people where you purchased the exhaust kit, it sounds like it cost you a lot of money, and i would be dissapointed to. Contact the manufacturer, because if the exhaust is supposed to be "taylor made" then the F1 light should not come on, and if it does, then they should be able to tell you why. If it's pre mapped, then you should get no error codes. Simple, ask the to fix it for free, or ask them for a refund, and by another system form a different manufactuer.
The FI light is an alert to you that the computer has found a Fuel Injection problem in the engine. The dealer can read the code and tell you what is wrong. You can then decide to have them fix it or do it yourself.
If your security lite is blinking on the dash board with the key on then your security fuel line is locked. quick
fix leave the key in the ignition for 10 minutes IN THE ON POSITION
<===very important to leave key in for ten minutes on the on
position! security lite should stop blinking and fuel will get into the
lines you may need to spray some quick start in the intake remove the air filter hose and spray in the intake and start her up. you
may have the same problem I ran into and have to turn your key on don't
start the car ye wait about ten seconds with key on on position the
turn it over should stop the security lite from coming on all the time
and locking the fuel lines. let me know if this worked
×