2003 Yamaha Road Star Warrior Logo
D
David McDowell Posted on Apr 20, 2014

My 2001 yamaha 1600 roadstar backfires and cuts out just before I shift. It idle fines. it runs good between gears. It cuts out just when it get up in higher rpms, just before I shift.

1 Answer

John Oughton

Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 40 Answers
  • Posted on Apr 20, 2014
John Oughton
Contributor
Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Jun 04, 2009
Answers
40
Questions
0
Helped
13744
Points
89

Backfiring and cutting out liike this is probably a symptom of one or both of the following: too rich a fuel mixture, or too weak a spark. Take your spark plugs and see if they tips look tan or black. If black, your fuel mixture needs to be leaned out. Another possible cause is a dirty and or clooged air filter, which can reduce the air flow into the engine. Take it out, bang the dust and debris out. If it looks really dirty, replace it -- they're cheap. If your spark is too weak, you may also notice a loss of power, especially at higher revs. If none of these seem to be the culprit, have your ignition timing checked.

Testimonial: "How do I check my ignition timing."

5 Related Answers

Anonymous

  • 921 Answers
  • Posted on Aug 19, 2010

SOURCE: How do you check the oil in a 2003 yamaha roadstar

all bike are to be checked in the upright position! then find out how much the bike takes from your manual if you dont have a manual ...do the following ..when you just change oil and not filter you will be adding less oil,"almost" all bikes take @ 3 quarts oil minimum, so what i do to be safe!! is always after draining is put in two quarts no problem, but with the third bottle i only pour in half.. drop oil cap back on and start the bike and let it run for a minute, the turn it back off, then check oil level, if it doesn't register anything on the stick or sight glass then your o.k. to add the rest. now take a reading, and only fill to almost full, i always under fill my bikes, because over filling will cause damage to internal bearing by the air bubbles from the splashing of the crank in the oil pan. Same as cars.
If you found this helpful can i get a rating?
Thanks

Ad

Anonymous

  • 2 Answers
  • Posted on Jul 22, 2009

SOURCE: Rpms speed up faster then bike does. Sounds like clutch slip.

You can adjust it by slackening the cable...unless it has hydraulic operation....Otherwise get it replaced before you do more damage..ie clutch dust and debris in the oil, so dont forget the oil and filter change too.

ROB

  • 858 Answers
  • Posted on Jul 20, 2009

SOURCE: 2007 yamaha ttr 125 wont go into gear. starts

gear selector may be jammed inside the casing or broken
check that the shifter is tight on the shaft!
check clutch adjustment
try rocking bike back n forth without using clutch while you try ******* the gear lever it may come unstuck
but get it looked at if it frees up!

ginocussen

Gino Cussen

  • 217 Answers
  • Posted on Mar 21, 2009

SOURCE: 1997 Yamaha FZR 600 cuts out when shift into first gear

Does the bike have a sidestand switch that cuts the power if the stand is left down? If it does, disconnect it and temporarily join the ends together and try starting....

Anonymous

  • 674 Answers
  • Posted on Nov 17, 2008

SOURCE: QUAD QUESTION! 1998 yamaha warrior 350 bogging down

sounds like fuel starvation
do you have a petcock plugging or a dirty carb?
pull the fuel line and check flow
later paul9477792.gif0e30a9b.gif

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2000 Yamaha Roadstar 1600 won't start

check the fuel flow and fuel filter.
1helpful
1answer

I have a 1999 Yamaha Roadstar 1600. I ride the bike for minutes or hours and the bike stops running. The bike has no electrical power and wont start leaving me stranded. If i wait a few hours the bike...

Check if the charging system works ok.
At idle with lights off, you should see 13.5-14.5V on battery's terminals and 0.5V less with high beams on, at idle speed as well as at 4000rpm.
Use a fresh good verified battery to take the readings.
2helpful
2answers

2001 roadstar 1600 suddenly developed flat acceleration at cruising speed. Plugs fine with nice light cocoa appearance, but changed them out anyway to NGK irridium. No difference. Bike accelerates, but...

want a great source for roadstar information? try roadstarclinic.com. you might have a sticking exhaust valve in the rear cylinder! they are known for it when they have the pipes and jet kits installed! if that be the case, I have a fix for it that is a lot cheaper than pulling the heads!
5helpful
1answer

Backfire after shutoff

With the key off and the engine "running down", the idle circuit fuel is still going to into each cylinder then out the exhaust. A hot spot in the exhaust can ignite the unburned fuel creating an explosion, ( backfire ). Let the engine run down to an idle THEN turn the key off.

Please rate this answer. Thanks!
Not finding what you are looking for?

2,810 views

Ask a Question

Usually answered in minutes!

Top Yamaha Experts

vince

Level 3 Expert

2530 Answers

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1212 Answers

littlewheel

Level 2 Expert

122 Answers

Are you a Yamaha Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...