SOURCE: Fitting Ducati 748 clutch slave cylinder to square case 900 1978
There is an hydraulic clutch replacement for the cable on a squarecase engine. No mods needed, just bolt on from memory. Fits a clutch master cylinder from a beltdrive Supersport and a custom slave inside the housing where the normal lever goes.
I will need to find the contact info for the bloke who does them though as it has been a while since I got the info myself.
Contact me at [email protected]
SOURCE: I cant get a spark from the cylinods on my 1998 ducati 748
this might help you trouble shoot your problem
http://www.800-airwolf.com/pdffiles/ARTICLES/part%2058.pdf
also never apply voltage to ducati coils without the coil being grounded, as they can split wide open!
SOURCE: 2000 ducati 748 running rough
I never heard that one, you should be able to see inside the tank and see if it is rusting or all gunked up. Pull the lines off and see if they run free and clean, change the filter, I would check the rubber lines to the fuel pump, they may be leaking air, vacuum assisted. Check the spark plugs. I had trouble with the champions, so I went and got Autolite 4163 plugs, they worked ten times better. 2002 S4 1999 750
SOURCE: Where are the spark plugs located on a 2002 Ducati
The plugs are located at the top of each barrel between the camshafts
Front cylinder - remove lower fairing & inner panels
Rear cylinder - remove fuel tank
Ride safe
Bike-Doc
Please mark this as very helpful (if it has been!!)
SOURCE: What's the right tire pressure for a ducati 748
Front tyre 2.2 Bar
Rear tyre 2.4 Bar
Assuming standard tyres are fitted, if not check your dealer for other specifications.
66 views
Usually answered in minutes!
×