Flooded - Pit Bike 125cc 4 Stroke Dirt Bike

50w Watt LED SMD Indoor Outdoor Flood Light Brightness Test

the G16 engine, floods.
there are 2 engines, G16a and b.
8valve TBI and the 16v MPI engine.
(EFI on both are radically different.)
this pages shows all 3 levels of diagnosis
3 causes. physics.
14 causes.
and then the full list.

http://www.fixkick.com/flooding.html


to find the cause takes tools.
got tools?, what to buy them.?
or just guess.?

here ill guess (useless)
1: the FPR reg is stuck closed, and fuel pressures 2x normal an it floods.

got 50 more...

post a photo of your engine and WIN>
get the first of millions, to do it.
amazing at it seems...

learn that almost all cars have
engine options
and transmissions.

can you explain what you mean by it floods

double posted, and fluids? you mean FLOODS.
see previous post,
there are other ways to flood any motor.
one other is (iSC /IAC devices are stuck closed) gummed up.
this cause no starting air, no air means flooding.
I cant see your car, and see if starting with 10% throttle solves the flood, but you can.
also WOT cranking, cuts all fueling and can not flood and will start any flooded engine.
but if this still floods,now, that is bad injectors. leaking.
WOT cuts injection pulses dead, and no fuel flows, cranking.
knowing these facts on EFI makes finding causes easy.

think you put a dodgy part on no doubt a cheapy made in china part ,try a genuine bosch

Define flooding.

1. Black smoke out of the tail pipe?
   

If the fuel return line is plugged,it will flood.If the fuel pressure regulator has lost its vacuum signal ,it will flood.

If there is a large vacuum leak,the O2 will see a lean condition and cause the rich condition.gas mileage will suck,big time.

This "flooding" happens when the engine is cold? ONLY?
Be sure the air filter is not clogged and the PCV is not plugged up solid.
Also,there are a few tubes from the valve cover that vents oil vapors into the air filter housing.

During this flood mode,hold the pedal to the floor and shut the engine OFF-it should NOT keep running.(Leaky injectors)...

Do this when engine is hot and cold.

Yes that can cause a flood.

Replace the coolant sensor NOW!? Its causing a flooding condition as evidenced by wet plugs that short out when flooded. Blip the starter and see if raw fuel is blown out as another indication of a flooded condition. In cases of flooded engines, holding the gas pedal to the floor shuts off the injectors during starting to clear out the cylinders.

The brass replacement sensor will cure flooding and many other engine/transmission issues.

The FL (Over Fill) error code indicates that the flood pressure switch is open (tripped). It is likely that you are getting the LD (Long Drain) fault code because the control detects that the flood pressure switch will not reset after running the drain pump. Your likely failure is in the flood pressure switch

Tapping on the flood pressure switch with the handle of a screw driver may reset it. Reassemble the washer and see if it will work properly. If not, then you will need to replace the flood pressure switch. The part number for the flood pressure switch is 8054767. You can order this part from the Sears PartsDirect website. The part number for the flood pressure switch is 8054767.

Your car is fuel injected. It shouldn't get flooded. (to answer your question, about 1/2 of an hour) Have it looked at, you may have a sensor issue.