Taken wirein loom of and not put bak properley evry time I connect battery it try 2 start

Your best bet is going to be www.alldata,com and it is not free.

Pin 1 - Signal (Green/Yellow) Pin 2 - Signal Return (Grey/Red) Pin 3 - Signal (Orange/Red) Pin 4 - +5V Reference (Orange/Yellow) Pin 5 - Ground (Black) Pin 6 - Not Used

it might be the remote.

There are two battery feeds to the radio

1...The main one that connects the battery supply via the Ignition Switch

2...A permanently connected battery that maintains the Code Memory and Tuning Settings Memory.

It looks as though the (2 ) is missing

Usual problem is a blown fuse or loose connector at rear of radio.

Can be tested using a Multi-Meter or Test Lamp

CLICK HERE for useful website with the connector pin diagrams

THIS DEPENDS ON WHETHER YOUR RECTIFIER HAS 5/ OR 7 WIRES, SIMPLE ENOUGH THOUGH , YOU WILL SEE THREE YELLOW WIRES THESE WILL COME FROM THE AC SIDE OF THE GENERATOR ON THE ENGINE TO THE RECTIFIER, IT IS HERE THE AC, ALTERNATING CURRENT IS CHANGED TO DIRECT CURRENT DC IS USED FOR STARTING THE BIKE, AND PROVIDING POWER FOR LIGHTS ETC, YOU WILL THEN FIND 1 OR 2 GREENS, GREEN IS THE BIKES EARTH ON OLDER HONDAS, SO PUT THESE WIRES TO A GOOD EARTHING POINT ON THE BIKE OR WIRE INTO THE LOOM , YOU WILL TEN FIND 1 OR 2 REDS, AS RED IS THE DC OUTPUT FROM THE RECTIFIER YOU WILL NEED TO CONNECT THIS TO THE POSOTIVE+SIDE OF THE BATTERY

I hope you put the battery in properley or els you can go to this sight for anny help http://www.retrevo.com/support/Nokia-N810-Tablets-manual/id/4357ci062/t/2/

hi put your 2 batteries in parallel with an isolator switch on both negative wires and another switch on the negative wire that joins the 2 batteries this way you can run on either battery and charge that battery or with the isolator between the batteries switched on charge both at the same time if you carn't understand it send me an e mail at [email protected] and i will draw it hope this helps merlin v 12

put the battery only when you are using the cameras.On other time dont put the battery in the camera and try

Hi Asadi Hope you doing good. Please try the following solution : 1. Disconnect the power cable. 2. Take out the battery 3. Keep holding down the power button for 60 seconds. 4. Put the battery back in. 5. Connect the power adapter 6. Make sure the Power adapter is switched on and laptop is on AC Power 7. Wait for 5 minutes and try to restart the computer 8. If it still doesn't starts. 9. Hold down the power button for 60 seconds with AC adapter and battery connected 10. Try to restart now and check. 11. If it still doesn't switch on 12. Take out the battery and run on only Ac adapter and restart. Please advise if this still doesn't helps. Regards Harry