2004 Harley Davidson FXDL - FXDLI Dyna Low Rider Logo
A
Anonymous Posted on Dec 25, 2013

Replacing fuel disconect2004 dyna low rider

Need to know how to put back the disconnect the end that goes in the tank

5 Related Answers

jecollinsii

  • 16 Answers
  • Posted on May 21, 2009

SOURCE: finding the oil plug on a 2006 Dyna Low Rider

on the left side of tranny its a 5/8 bolt

Ad

Anonymous

  • 113 Answers
  • Posted on Sep 05, 2009

SOURCE: 93 Dyna low rider fork oil.

your local hd shop should be able to answer this for you as its a mesured amount and to much or too little will make the bike not handle right

Anonymous

  • 31 Answers
  • Posted on Sep 13, 2009

SOURCE: Add transmission fluid to 2001 Harley dyna low rider

the tranny plug is behind the oil spout its usually a big allen head bolt. You should use a quality oil like AMSOIL 20W50 motorcycle oil or AMSOIL gear oil. I have the 20W50 in mine and really like the benifit of not having a pultrolium product in my bike. You can get the AMSOIL online a http://hbsynlube.com/sales. You'll beglad you changed it.

Anonymous

  • 4565 Answers
  • Posted on Sep 24, 2009

SOURCE: how do you remove battery from dyna low rider

I have an early model and I think they're still the same in that area. There are two bolts on the right side of the battery support. Loosen these two bolts and the battery will drop down a bit allowing you to remove the battery top cover and front cover.

Anonymous

  • 50 Answers
  • Posted on Oct 19, 2009

SOURCE: What is the fork oil capacity for a 2004 Dyna Low

If I am not mistaken. You will need ten ounces per side ounce you have completely drained them

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2006 ultra classic gas tank removal

Remove the seat. THEN remove the electrical caddy cover THEN purge the fuel supply line of high pressure gasoline by removing the fuel pump fuse, starting the engine and letting it run until it quits and then turning it over for another few seconds and then disconnect the fuel line from the tank. Then disconnect the negative battery cable and then reinstall the fuel pump fuse. THEN remove the instrument panel from the fuel tank and disconnect the wiring connector and the fuel gauge connector under the tank THEN remove the fuel from the fuel tank. Then cut off the fuel crossover line hose on one side of the tank and pull the 5/16 inch hose from the fuel pipe there and plug it and install a cap over the pipe. THEN disconnect the vent line from the tank. THEN remove the front mounting bolt and the rear mounting bolt and remove the tank.
0helpful
1answer

How do you remove gas tank from 2003 dyna low rider

Remove the instrument console and the front and rear mounting bolts and then the instrument wiring and the overflow hose and the fuel line at shut off valve making sure the valve is "OFF" and drain the tank and then remove the crossover hose at one side and plug line and hose and then disconnect fuel gauge connector at left side of frame under the tank.
0helpful
1answer

How to change the starter on a 1997 dyna low rider

Disconnect the negative battery cable. Drain the primary case. Remove the primary cover and take the bolt out of the jackshaft and remove it. There is a coupling between the starter motor and the jackshaft. It should not come out with the jackshaft but when you take the starter out, it will come out with it. Remember, the counterbored end goes towards the jackshaft. Put the coupling on the starter before installing it on the bike. On the right side of the bike, you'll probably have to remove some or all of the exhaust system. Take anything else off that may be in your way. Take the battery cable and the single wire that goes to the solenoid off of the starter and remove the two large socket head bolts that holds the starter on.

Good Luck
Steve
4helpful
2answers

Where is FXDL dyna low rider gas filter located ?

It doesn't have a filter, it does have a screen and it's located in the fuel tank. If your bike is carb equipped and has a petcock, take the petcock out and the screen comes with it.

If your bike is fuel injected, you have to take the pump out of the tank.

Good luck
Steve
0helpful
1answer

Need to know how n where to put wires under tank on 2000 low rider

The wires usually run down along side the top tube of the frame or are underneath it held by wireties.

Good Luck
steve
0helpful
1answer

Changing a headlight on a 06 Low Rider

mark up all connections with tape you can write on, so you know where they go when you put them back. disconnect them all then pull them thru the hole in the back of the headlight.
0helpful
2answers
Not finding what you are looking for?

181 views

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...