Diagram of rear wheel assembly on 2009 Harley Davidson Street Glide
SOURCE: replace rear brake pads
Remove right saddlebag, pull the two caliper mounting bolts and remove the caliper. Do not open bleeder or disconnect line. You will need to push a large screwdriver between the old pads before removing them in order to push the pucks back into the caliper or the new pads will not spread enough to reinstall. Then pull the two smaller bolts from the caliper and the pads will fall out. The pads are different for inside and outside, so pay attention, and remember, after reinstalling, before riding, be sure to pump brake pedal, and it may take a few stops before brakes stop as effectively as before.
SOURCE: air in rear shocks
Depending on your weight and if you carry a passenger as to the air pressure. I normally run about 14 but 24 if riding 2 up.
Recommended pressures:
up to 150 lbs- 0
each addition 25 rider pounds > 150 lbs add 1.0 lbs
each additional passenger pounds > 150 lbs add 1.5 lbs
each additional 10 lbs of laggage add 3.0 lbs
Max Pressure 35 psi
SOURCE: brake light
front brake lever not depressing brake light button. inside throttle housing or I had a guy the other day thought brake light was stuck on (found burnt fillament brake light)
SOURCE: Harley Davidson street glide idles low and sometimes dies at stop signs?
2004 springer put plugs in fouled out in 5 minutes black smoke out pipes any suggestions
SOURCE: How do I change the front and rear brakes on a
Not too hard - Undo the two bolts on the caliper and then seperate the caliper and pull the old ones out. Insert the new ones and put the bolts back in to hold the caliper back together and then install them back on the bike with the two retaining bolts. Use a bit of lock tight (Blue) on the threads. Warning do not let anyone apply pressure on the brakes while you have them off the bike or you will have a mess and/or a problem.
275 views
Usually answered in minutes!
×