2002 Harley Davidson FXDL Dyna Low Rider Logo
A
Anonymous Posted on Oct 27, 2013

Size fuse for dyna low rider battery to starter 2003

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Nov 30, 2008

SOURCE: harley davidson dyna low rider 2003 battery does not last when ri

I had this problem on my ultra clasic. I found a ground wire loose. you will have to locate all ground wires. and don,t frget the one on the battery.

Ad

Anonymous

  • 113 Answers
  • Posted on Sep 05, 2009

SOURCE: 93 Dyna low rider fork oil.

your local hd shop should be able to answer this for you as its a mesured amount and to much or too little will make the bike not handle right

Anonymous

  • 31 Answers
  • Posted on Sep 13, 2009

SOURCE: Add transmission fluid to 2001 Harley dyna low rider

the tranny plug is behind the oil spout its usually a big allen head bolt. You should use a quality oil like AMSOIL 20W50 motorcycle oil or AMSOIL gear oil. I have the 20W50 in mine and really like the benifit of not having a pultrolium product in my bike. You can get the AMSOIL online a http://hbsynlube.com/sales. You'll beglad you changed it.

Anonymous

  • 4565 Answers
  • Posted on Sep 24, 2009

SOURCE: how do you remove battery from dyna low rider

I have an early model and I think they're still the same in that area. There are two bolts on the right side of the battery support. Loosen these two bolts and the battery will drop down a bit allowing you to remove the battery top cover and front cover.

Anonymous

  • 109 Answers
  • Posted on Mar 24, 2010

SOURCE: how to change primary chain tension on 2007 Harley

Sorry, not up on new hogs but I think you remove plate off outer primary,it's got the foot peg mounted on it.Look through hole and you'll see the bolt that holds the chain support unit.Carefully loosen bolt and pry up or down,tighten or loosen, tension.You don't have belt right? some newer ones do.If you want hi-tech and yours doesn't have one already remove the outer primary and replace the "skidplate" adjuster with a roller type.Makes things quiet.There is room in the hole to check that you don't get chain too tight.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

TRIED TO START 2002 DYNA LOW RIDER. turned key on,run switch to run and hit satr it turned over and fired once then nothing ,did not click or turn over when hitting start. waited a while and tried again...

Make sure battery has a full charge and both positive and negitave battery connections are clean and tight.Make sure unit is in nuteral and try to crank. If engine wont crank check starter selonid or relay. MAKE SURE BATTERY HAS A FULL CHARGE.
0helpful
1answer

Dyna starter just spins

The starter has a centrifical clutch. It works by using small roller bearings that sling to the outside and tighten up as the starter turns. Some models might be a bit different in design.
1helpful
1answer

How do you remove the battery from a 2003 dyna low rider?

On the right side of the bike there is a cover right under the rider seat. remove the cover and the battery is behind this cover.
1helpful
1answer

Where does the long black wire on the regulator go to on a 2003 harley dyna

This is the wire that goes to the battery to recharge it. Now, You can connect it directly to the positive post of the battery, to the copper post of the circuit breaker, or to the bolt on the starter where the large battery cable connects. Either place it will be connected either directly or indirectly to the positive post of the battery.

Good Luck
Steve
1helpful
1answer

How do I change the battery on my 03 Dyna low rider

just left of the battery is two bolts remove the bottom one and loosen the other to lower the battery remove cover and side cover pull battery out a little and remove the neg. cable first then you should be able to to the battery out a little more to get to the pos.
1helpful
1answer

Transmission filler plug wrench size?

I haven't looked at a 09 model but earlier models used a 7/16 inch allen key.
3helpful
1answer

How to take starter out

Disconnect the battery, remove the outer primary cover. Remove the jackshaft bolt, lockwasher and seal. remove the battery box and battery. remove 2 starter bolts 1/4 allens, and remove the green wire terminal ( the 50 terminal ) .

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_5bac37c3cb991fdb

Not finding what you are looking for?

224 views

Ask a Question

Usually answered in minutes!

Top Harley Davidson Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Harley Davidson Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...